Owner`s manual

INSTALLATION STEP 9

Fasten Door Bracket and Plate

Follow instructions which apply to your door type as

illustrated below.

TO PREVENT DAMAGE TO LIGHTWEIGHT

AND METAL GARAGE DOORS {OR ONES

WITH GLASS PANELS).

ALWAYS REINFORCE THE INSIDE OF DOOR BOTH

VERTICALLY AND HORIZONTALLY WITH 2x4

BOARDS OR ANGLE IRON.

The horizontal brace should be at least 6 feet long. The vertical brace should cover height of top panel. The best solution is

to check with your garage door manufacturer for an opener Installation door reinforcement kit.

Sectional Door Installation Procedure

All One-Piece Door Installation Procedure

NOTE: The door bracket has left and right side

fastening holes. Use bracket and plate assembly if

you require top and bottom fastening holes.

Center bracket (with or without plate as required) on top

edge of door as shown. Mark holes.

Drills 5/16” holes and fasten the door bracket with

hardware supplied.

NOTE: If the door has no exposed framing, drill

3/16” pilot holes and use 5/16” x 1-1/2” lag screws

(not supplied) to fasten bracket to top of door.

NOTE: The door bracket may be installed on face

of door if required for your installation. (Refer to

dotted line drawing.) HOWEVER, drill 3/16” pilot

holes and substitute 5/16” x 1-1/2” lag screws

(not supplied) to fasten the bracket to the door.

Position door bracket and plate assembly

against door within the following limits

according to your requirements (and centered

on vertical guideline or up to one foot left or

right of center if necessary):

A) Top edge of bracket 2” - 4” below top edge

of door.

B) Directly below any structural support

across top of door.

Mark and drill 5/16” fastening holes. Secure

bracket assembly as shown.