Owner`s manual

INSTALLATION STEP 10

Connect Door Arm to Trolley

Follow instructions which apply to your door type as

illustrated.

SECTIONAL DOORS ONLY

Make sure garage door is closed tight. Pull the manual release handle to disconnect the trolley. Manually

move

outer trolley back to the center of Inner trolley as shown in Figures A, B and C.

FIG A: Fasten straight door arm section to outer trolley

with a clevis pin. Secure the connection with a ring

fastener.

Fasten curved section to the door bracket in the same

way.

FIG B: Bring arm sections together. Find two pairs of

holes that line up and join sections. Select holes as far

apart as possible to increase door arm rigidity.

FIG C: If holes in curved arm are ABOVE holes in

straight arm, disconnect straight arm. Cut about 6" from

the solid end. Reconnect to trolley with CUT END

DOWN as shown.

Bring arm sections together. Find two pairs of holes that

line up and join with screws, lock washers and nuts.

Proceed to Step 1, page 20. Trolley will re-engage automatically when opener is operated.