Owner`s manual

Before you begin, please check the contents of the carton. Illustrations of parts and hardware are shown on Pages 26 and
27. Separate the hardware for assembly and installation as shown.
FEATURES OF YOUR OPENER
1. Opener Light(s): Turns on and off automatically
with 4-1/2 minute illumination for your safety and
convenience.
2. Manual Release Handle: Pull cord disconnect
permits manual door operation in case of an
emergency or power failure.
3. Safety System: Independent up and down force
adjustment. The door REVERSES automatically
when obstructed in DOWN direction. The door
STOPS when obstructed in UP direction.
4. Motor Power: Permanently lubricated motor with
automatic reset.
5. Automatic Reconnect: Trolley halves reconnect for
automatic operation when opener is activated after
a manual disconnect.
6. Digital Radio Controls: Codes can be set and
changed easily and as often as you would like.
7. Easy Limit Adjustment: Limits of door opening and
closing adjusted by turning screws without removing
opener covet.
YOU'LL NEED TOOLS
During assembly and installation of your opener, instructions will call for the use of various hand tools shown below
3
MOTOR
Type ...................................Permanent split capacitor
Speed ................................1500 rpm
Volts...................................120 Volts AC - 60 Hz. Only
Current...............................4.5 amperes
DRIVE MECHANISM
Gears.................................16:1 worm gear reduction
Drive...................................Chain & cable with two-piece trolley on steel T-
rail
Length of travel.................. Adjustable to 7 1/2 bet
Travel rate......................... 6 to 8 inches per second
Lamp..................................On when door starts to travel. off 4/2
minutes after stop, Model 5000
has separate Light Switch feature.
Door linkage.......................Adjustable door arm. Pull cord trolley release.
SAFETY
Personal.............................Push button and automatic reversal in DOWN
direction. Push button and automatic stop in
UP direction
Electronic...........................Independent UP and DOWN force
adjustment screws
Electrical.............................Motor overload protector & low voltage push
button wiring
Limit device........................Circuit actuated by limit nut
Limit adjustment.................screwdriver adjustment on side panel
Start circuit...........................Low voltage door button or radio control
DIMENSIONS
Length (overall)..................124 inches
128 inches
Headroom required............2 inches
Hanging weight.................32 pounds