Owner`s manual

Operation of Your Opener
CAUTION
• BEFORE YOU PROCEED, PLEASE READ SAFETY RULES
ON PAGE 2 AND THE OPERATING INSTRUCTIONS ON
THIS PAGE CAREFULLY
• TO
AVOID DIFFICULTY DURING INSTALLATION, DO NOT
RUN OPENER UNTIL INSTRUCTED TO DO SO.
• DO NOT
PERMIT CHILDREN TO PLAY IN THE AREA OF THE
DOOR.
• OPERATE ONLY WHEN OPENER IS PROPERLY ADJUSTED
AND THE DOOR IS VISIBLE AND UNOBSTRUCTED.
HOW TO ACTIVATE THE OPENER
Use any of the following devices:
1. The Remote Control Transmitter. Hold the push
button down until the door starts to move.
2. The Door Control Button. Hold the button down until
the door starts to move.
3. The Key Switch or Wireless Keyless Entry System
(if you have installed either of these accessories).
OPENER LIGHT(S) will turn on under the following
conditions: when the opener is initially plugged in; when
the power is interrupted; when the opener is activated.
Light(s) turns off automatically after minutes. Bulb size is
75 Watts maximum.
If the Multi-Function Control Panel (with the Light Switch
Feature) is installed, the light can remain ON or turn OFF
before the automatic cycle is completed. if desired.
HOW TO OPERATE THE DOOR MANUALLY
HOW DOOR MOVES WHEN OPENER ACTIVATES:
DOOR SHOULD BE FULLY CLOSED IF POSSIBLE.
WEAK OR BROKEN SPRINGS COULD ALLOW AN
OPEN DOOR TO FALL RAPIDLY. PROPERTY DAMAGE
OR SERIOUS PERSONAL INJURY COULD RESULT. DO
NOT USE MANUAL RELEASE HANDLE TO PULL DOOR
OPEN OR CLOSED.
1. If open, door will close. If closed, door will open
.
2. if closing, the door will reverse.
3. It opening, the door will stop (allowing space for entry
and exit of pets and for fresh air).
4. If the door has been stopped in a partially open
position, it will close.
5. If an obstruction is encountered while closing, the door
will reverse.
6. If an obstruction is encountered while opening, the door
will stop.
7. The optional Protector System™ uses an invisible
beam which, when broken by an obstruction, causes a
closing door to open and prevents an open door from
closing. It is STRONGLY RECOMMENDED for
homeowners with young children
Disconnect door from opener by pulling down sharply on
red handle. Lift door manually. To automatically
reconnect door to opener, press Door Control Button.
LOCKOUT FEATURE: prevents trolley from reconnecting
automatically. If you need to use this feature, pull Manual
Release Handle down and back (toward opener). Trolley
will remain "Locked-Out" and door can be raised and
lowered manually. To reconnect trolley. Dull Manual
Release Handle straight down.
ACCESSORIES AVAILABLE FOR YOUR OPENER
Model 753CB
Standard Multi-Function Remote
The Multi-function remote control transmitter
can activate one or more door openers
and/or light controls.
Model 740CB
Wireless Keyless Entry System
Enables homeowner to operate garage
door opener from outside by entering
code on specially designed keypad.
T-rail Extension Kit
With a longer section of T-rail & a
chain/cable assy. to allow 8 foot or 10 foot
doors to open fully.
Model 7704CB - 8'
Model 7710CB -10'
Model 750CB
Single-Function Remote with
visor clip
Models 756CB & 756GMH
Mini Multi-Function Remote
Multi-Function Control Panel
Provides a Lock Switch which prevents
operation of garage door opener from
remotes and a Light Switch for constant
light.
Model 760CB
Model 745CB
Model 70
Outdoor Key Switch
Opens garage door automatically from
outside when remote control transmitter is
not handy.
'The Protector System'
Provides auxiliary support to the safety
features built into your opener. The
system's invisible beam, when broken by
an obstruction, causes a closing door to
open and prevents an Open door from
closing.
Model 7702CB
Emergency Release Keylock
REQUIRED for a garage with NO
service door.
Allows manual operation of garage door
from outside in case of power failure.
5