Owner`s manual

CAUTION: Do not tighten the lock nuts until bolt

necks are seated in square holes and rail sections

are positioned correctly (see right

and wrong views

below.

TO AVOID INSTALLATION DIFFICULTIES, DO

NOT RUN THE GARAGE DOOR OPENER UNTIL

INSTRUCTED TO DO SO.

ASSEMBLY STEP 1

Assemble T-rail &

Attach Cable Pulley Bracket

T-bar braces MUST be positioned against

rail sections as shown.

Otherwise they will hit against nut when

installed.

PROCEDURE: Place the 4 T-rail sections on a flat surface

for assembly. THIS IS IMPORTANT.

Center sections are interchangeable. Front and back

sections are also interchangeable for ease of assembly.

Study the illustration carefully and connect T-bar braces to

rail sections from direction shown.

SQUARE NECKS ON CARRIAGE BOLTS MUST BE

SEATED IN SQUARE HOLES IN RAIL SECTIONS.

Position the cable pulley bracket on front end

of T-rail as shown. Fasten securely with the

hardware provided.

IMPORTANT: When tightening screws, be

sure to keep bracket parrallel to rail.

Otherwise, rail may bow when opener is

operated.