Operator`s manual

POWER BAR
This Lithium-Ion battery pack is equipped with a POWER BAR, which is used to
display the battery pack's remaining run time. Press the POWER BAR button to
display the LED lights. The LED lights will remain lit for approximately 4 seconds.
NOTE: The POWER BAR can be used whether the battery is attached or
removed from tool.
80-100% Charge
60-79% Charge
40-59% Charge
0 0 0 0 20-39% Charge
O O O'_(_[" under 10% Charge
-[_"¢-'_-'_'- Completely discharged
LOW-BATTERY CAPACITY INDICATOR
• If one LED light on the POWER BAR begins to rapidly and continuously
flash when the trigger switch on the wrench is depressed, the battery pack's
power has run out, and the battery pack should be recharged.
Unlike other battery pack types, Lithium-Ion battery packs deliver fade-free
power for their entire run time. The tool will not experience a slow, gradual
loss of power as you work. To signal that the battery pack is at the end of
its run time and needs to be charged, the power to the tool will drop quickly.
The POWER BAR will begin to display four flashing LED lights when the
battery is completely discharged. When this happens, remove the tool from
the workpiece, and charge the battery pack as needed.
NOTE: The POWER BAR may also display four flashing LED lights due to an
overload or high temperature situation (see SmartChip TMBattery protection).
66810 ManuaLRevised_09 0407 Page i5