Operator`s manual

DIRECTION-OF-ROTATION SELECTOR (FORWARD/REVERSE/CENTER
LOCK) (Fig. 6)
The direction of bit rotation is reversible and is controlled by a selector located
above the trigger switch. With the Impact Wrench held in normal operating
position:
1. Position the direction-of-rotation selector to the left of the tool for
forward rotation.
2. Position the direction-of-rotation selector to the right of the tool for
reverse rotation.
3. Setting the switch in the OFF (center lock) position helps reduce the
possibility of accidental starting when not in use.
CAUTION: To prevent gear damage, always allow the Impact Wrench to
come to a complete stop before changing the direction of rotation.
NOTE: The Impact Wrench will not run unless the direction-of-rotation selector
is engaged fully to the left or
LED WORKLIGHT (Fig.7)
The LED worklight, located on the
base of the Impact Wrench, will
illuminate when the trigger switch
is depressed. This provides
additional light on the surface
of the workpiece for operation
in lower-light areas. The LED
worklight will turn off when the
trigger switch is released.
Fig. 7
66810 Manual_Revised_09 0407 Page 20