Operator`s manual

• If liquid from the battery gets in your eyes, flush them with clean water for at
least 10 minutes, and then seek immediate medical attention. Following this
rule will reduce the risk of serious personal injury.
SERVICE
Have your power tool serviced by a qualified repair person using only identical
replacement parts. This will ensure that the safety of the power tool is
maintained.
®
®
When servicing a power tool, use only identical replacement parts.
Follow instructions in the Maintenance section of this manual. Use of
unauthorized parts or failure to follow Maintenance instructions may create a
risk of shock or injury.
SPECiFiC SAFETY RULES FOR CORDLESS iMPACT WRENCH
Hold power tools by insulated gripping surfaces when performing an operation
where the cutting tool may contact hidden wiring or its own cord. Contact with
a "live" wire will make exposed metal parts of the tool "live" and shock the
operator.
Use clamps or other practical way to support and secure the workpiece to a
stable platform. Holding the work by hand or against your body is unstable
and may lead to loss of control.
Do not drill, fasten or break into existing walls or other blind areas where
electrical wiring may exist. If this situation is unavoidable, disconnect all
fuses or circuit breakers supplying the worksite.
Always wear safety goggles or eye protection when using this tool.
Bits, sockets, and tools get hot during operation. Wear gloves when
touching them.
Wear ear protectors when using the tool for extended periods. Prolonged
exposure to high intensity noise can cause hearing loss.
Use thick, cushioned gloves and limit the exposure time by taking frequent
rest periods. Vibration caused by hammer-drill or Imapct wrench action may
be harmful to your hands and arms.
Secure the material being fastened. Never hold it in your hand or across your
legs. Unstable support can cause loss of control and injury.
Avoid accidental starting. Be sure the forward/reverse switch is in the OFF
position before inserting a battery pack. Carrying appliances with your finger
on the switch or inserting the battery pack into an appliance with the switch
on invites accidents.
Remove battery pack before changing accessories. Accidental starting may occur
because battery appliances with a battery inserted are in the operative condition.
Be prepared for a reaction torque when "seating" or removing a fastener. The
tool housing may tend to twist in the opposite direction of bit rotation when
"seating" or removing a fastener, depending on the torque setting of the tool.
66810 ManuaLRevised_09 0407 Page 9