NA503S-4G Multiple RF Home Gateway i
User Guide Table of Contents CHAPTER 1 INTRODUCTION.............................................................................................. 1 Package Contents .............................................................................................................. 1 Features .............................................................................................................................. 1 LEDs ...........................................................................................
Chapter 1 Introduction 1 This Chapter provides an overview of the Multiple RF Home Gateway's features and capabilities. Congratulations on the purchase of your new Multiple RF Home Gateway. The Multiple RF Home Gateway is a consumer electronic device, which is designed to bridge all appliances of your home, from IP cameras to sensors, and allow you to monitor and manage them over the Internet. Most of the devices can be paired with the gateway via a single button push.
LEDs Front Panel The Multiple RF Home Gateway has 1 Multi-Color LEDs. POWER (Green) On - Power On/Normal Operation Off - Power Off Rear/Side Panel Power Port Connect the supplied power adapter here. ETHERNET Port Use a standard LAN cable (RJ45 connector) to connect your PC to the port. Reset This button has two (2) functions: Reboot. When pressed and released, the Multiple RF Home Gateway will reboot (restart). Clear All Data.
Button Panel Battery on/off switch On – System is powered by battery (default). Off – System is not powered by battery, but could be charged if AC adapter is plugged into device.
Chapter 2 Initial Installation 2 This Chapter covers the software installation of the Multiple RF Home Gateway. Requirements Use a standard 10/100/1000 Base T network (UTP) cable with RJ45 connector. Procedure 1. Choose an Installation Site This Gateway is designed for using in fixed position. Please select a suitable place to install the Multiple RF Home Gateway. 2. Connect LAN Cable Use a standard LAN cable to connect the device to the Ethernet port on the Multiple RF Home Gateway. 3.
Initial Installation SIM Card Installation 1. 2. 3. Ensured the device is powered off. Remove the screws on the back cover of the device with a screwdriver. Find the location of the SIM card tray. 4. Push the SIM card cover upward. 5. Insert the SIM card into the slot. Make sure the SIM card is installed correctly. Put the SIM card cover back. Attach the back cover to the device with the screws. 6. 7.
Chapter 3 Configuration 3 This Chapter provides Setup details of the Gateway. Configuration The Multiple RF Home Gateway can offer customers with seamless communication between devices and clouds while at home or away. This gateway is designed to provide complete connectivity with all certified devices including cameras, security systems and WiFi/ZigBee/ZWave/BLE client devices.
Appendix A Specifications A Multiple RF Home Gateway Model Multiple RF Home Gateway Dimensions 145mm(W) * 145mm(D) * 540mm(H) Operating Temperature 0 C to 40 C Buttons 1 Network Protocol: TCP/IP Network Interface: 1 * 10/100/1000BaseT (RJ45) LAN connection LEDs 1 Battery 2S1P 18650 Battery SIM Card Slot 1 Power Adapter 12V, 2A Regulatory Approvals FCC Statement Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits
FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
