Owners manual

English
BATTERIES
These batteries have been designed to provide maximum
trouble-free life. However, like all batteries, they will
eventually wear out. Do not disassemble battery pack
and attempt to replace the batteries. Handling of these
batteries, especially when wearing rings and jewelry, could
result in a serious burn.
For battery pack storage longer than 30 days:
 Store the battery pack where the temperature is below
80°F and away from moisture.
 Store battery packs in a 30%-50% charged condition.
 Every six months of storage, charge the pack as normal.
BATTERY PACK REMOVAL AND PREPARATION
FOR RECYCLING
To preserve natural resources, please recycle
or dispose of batteries properly.
This product contains lithium-ion batteries.
Local, state or federal laws may prohibit
disposal of batteries in ordinary trash.
Consult your local waste authority for information regarding
available recycling and/or disposal options.
WARNING: Upon removal, cover the battery
pack’s terminals with heavy-duty adhesive tape. Do
not attempt to destroy or disassemble battery pack
or remove any of its components. Batteries must be
recycled or disposed of properly. Also, never touch
both terminals with metal objects and/or body parts
as short circuit may result. Keep away from children.
Failure to comply with these warnings could result in
fire and/or serious injury.
OPERATION
MAINTENANCE
If the tool stops during use, release the trigger to reset
and resume operation. If the tool still does not work, the
battery needs to be recharged.
COLD WEATHER OPERATION
The lithium-ion battery pack can be used in temperatures
down to 5° F (-15° C). Put the battery pack on a tool
and use the tool in a light duty application. After about
a minute, the pack will warm up and begin operating
normally.
CHARGING THE BATTERY PACK
See Figure 1.
Battery packs are shipped in a low charge condition to
prevent possible problems. Therefore, you should charge
prior to first use. If the charger does not charge the battery
pack under normal circumstances, return both the battery
pack and charger to your nearest Authorized Service
Center for electrical check.
 Charge the battery pack only with the recommended
charger.
 Refer to charger operator’s manual for charging
instructions.
CHARGING A HOT BATTERY PACK
When using a tool continuously, the battery pack may
become hot. A hot battery pack may be placed directly
onto the charger port but charging will not begin until
the battery temperature cools to within acceptable
temperature range. When a hot battery pack is placed
on the charger, the charger may indicate the pack is
not ready to charge. Please refer to charger operator’s
manual. When the battery pack cools, the charger will
automatically begin charging.
Craftsman Consumer Helpline: 1-800-932-3188
Sears Brands Management, 3333 Beverly Rd.
Hoffman Estates, IL 60179 USA
Visit the Craftsman web page: www.sears.com/craftsman
SAVE THESE INSTRUCTIONS
990000209
10-2-12 (REV:03)
CHARGING A COLD BATTERY PACK
A cold battery pack may be placed directly onto the
charger port but charging will not begin until the battery
temperature warms to within acceptable temperature
range. When a cold battery pack is placed on the charger,
the charger may indicate the pack is not ready to charge.
Please refer to charger operator’s manual. When the battery
pack warms, the charger will automatically begin charging.
PP2020
PP2030
BATTERY
GAUGE BUTTON
BATTERY
GAUGE BUTTON
Fig. 1
DEPRESS LATCHES
TO RELEASE
BATTERY PACK
ON BOARD
ENERGY
INDICATOR
C3 ENERGY
INDICATOR
WINDOW