Instruction Manual

Process:

• Place the workbench in its upright position.

• Attach Back Stop to back of workbench top using (6)

#14-10 x 5/8" Hex screws by aligning the holes in the

backstop with the pre-drilled holes in the bottom of the

workbench top.

NOTE: On some units two of the holes required are not

pre-drilled. You will need to predrill the holes prior to

attaching the screws. Using the back stop as a guide, use

a 7/32" DIA drill and drill a 1" deep hole at each end of the

back splash.

• Wrench tighten all screws securely. Do not over tighten.

OPERATION

Items Needed:

Back Stop (Qty: 1)

#14-10 x 5/8" Hex Screw (Qty: 6)

Leveling Foot Adjustment

• Adjust leveling foot to desired position with a 5/8" open

end wrench as shown.

Some units may need

to have these holes

added

Process:

• Attach Rail as shown using (4) 5/16-18 x 3-1/2" carriage

bolts and (4) 5/16-18 Flange nuts. Flanges of rail should

face towards the front of the workbench. Adjust back Leg

Weldment to desired height before attaching bolts.

Items Needed:

Rail (Qty:1)

5/16-18 x 3-1/2" Carriage Bolt (Qty :4)

5/16-18 Flange Nut (Qty:4)