User manual

position for the friction wheel. See Friction Wh
Figure 30.
II
Loosen Bolts
Lev(
Figure 30
2. Install the bottom panel. See
Figure 28.
3. Tighten the bolts on each side of
the bottom panel.
4. Install the bolts on each side of the
bottom panel.
How To Replace The Friction Wheel
If the friction wheel is worn or damaged,
the snow thrower will not move forward.
The friction wheel must be replaced as
follows.
1. Remove the gas from the gas tank.
Stand the snow thrower up on the
front end of the auger housing.
_IL ARNING: Drain the gasoline
outdoors, away from fire or
flame.
2. Disconnect the spark plug wire.
3. Remove the top bolts on each side
of the bottom panel. See
Figure 28.
4. Loosen the bottom bolts on each
side of the bottom panel.
5. Remove the bottom panel.
6. Remove the three fasteners that
hold the friction wheel to the hub.
See Figure 31.
F-001087J 25
Hub
Bolt
Hex Nut
Shaft
Figure 31
7. Remove the four bolts that hold the
bearing plates on each side of the
hex shaft. See Figure 32.
NOTE: Take special note of the
position of the washers and retain-
ing ring on the hex shaft and the
sprocket assembly.
Friction Wheel Hex Shaft
Bearing _g
Plate Plate
Figure 32
8. Remove the bearing plate from the
right side. Do not remove the hex
shaft. Leave the hex shaft in posi-
tion. Carefully raise hex shaft just
enough to allow the friction wheel
to be removed.
9. Remove the friction wheel from the
hub. Slip the friction wheel toward
the right off the hex shaft. See
Figure 31.
10. Assemble the new friction wheel
onto hub with the fasteners re-
moved earlier.
11. Install the bearing plate onto the
right side. Make sure the hex shaft
is engaged with both bearing
plates and that the washers and re-
taining ring are installed in the origi-
nal position. See Figure 32.