Specifications

TRIMMER HEAD LINE iNSTALLATION

LARGEBUMP FEEDHEAD (,095" Line)

1. Lock shaft by inserting allen key into groove_ Loosen

by turning head as shown for straight shaft,,if your

model is a curved shaft, loosen by turning opposite

the direction shown in (Fig. 3t),.

2, Depress tab and twist trimmer head body CWto

disassemble (Fig, 32)_

Rg31

. Tab

Top vie___

"_ "Trimmer Head Body

Fig32

3. If using new line from a bulk spool, cut 2 pieces of

line 7.,5' (2.28 m) long. Insert each line into one of the

holes on each retention hook opposite of the direc -

tion of the rotation about 1/2 in (12-7 ram) deep

4oWrap line !80 ° and wind extra line in the opposite

direction of rotation of the head (Fig_33)°

Retention

Hook

6oSnapthe free length of linesinto top grooves in reel and pull

through holeson trimmer head body (Fig°34and Fig.35),

Trimmer Head

Body

_-----Sp ting

,_-.---- Bump Feed

Bullon

Trimmer Head Body

Fig35 Bottom

7 Close assembly in sequence as shown in (Fig° 35)°

8, Reassemble by lining up the 4 tabs on trimmer head

body and bottom,, Turn CCWuntil "click" (Fig. 36).

Tab *dick"

Fig 36

9.,Insert allen key into hole, tighten head by turning

as shown for curved shaft and opposite for straight

shaft (Fig, 37).

Fig,33

SoWind cord in direction indicated (CW)leaving 6 in (15-20 cm)

accessto pull through holestrimmer head body {Fig.34)°

Fig3 7

Fig 34

_. ,,J