Owner's Manual

I PROBLEM CAUSE SOLUTION !

Wood edges away fromrip Ripfence is misaligned. Check and adjustthe ripfence.

fencewhen ripping. Blade not properlyeh,_rpenedor Reeharpenor set blade.

set,

Slidingmiter table aSSembly Miterbase orslidesimproperly See page 26 for adjustments to sliding

does not movesmoothly, adjusted, miter table assembLy.

Saw does not make accurate 90 Posltlvestops insidecabinetneed Adjustpositivestops.

or 45 degree cuts. adiusting(BevelCuts):

Miter gaugeismisaligned(Miter Adjustthe mitergauge.

Cuts).

Blade adjustinghandleis hard Gears or Screw Post inside Clean thegears or screw poet.

to turn, cabinetare ckiggsd with

dust.

Saw does notstart. Motor cord or wall cord is not Plugin motor cordor wall cord.

pluggedin.

Cirouitfuse isblown.

Circuitbreakeristripped.

Cordor switch is damaged.

Replace circu'_fuse.

Resetcircuitbreaker.

Have the cordor switchreplacedat your

SearsServiceCenter/Department.

Blade makes poor cuts.

Bladeisdull ordirty.

Blade is wrongtypefor cutbeing

made.

Bladeismounted backwards.

Clean, sharpen,or replace blade.

Replacewith correcttype.

Remountblade.

Bladedoes not lowerwhen

turning bladeadjustinghandle.

Backside of rivingknifehas

comein contact wff.hsaw table.

Lockinglever is notat full left

position.

Realignand adjusttherivingknife.

Move _ockingleverto left.

Motor taborsinrip cut,

BJadenotproper for rip cut. Change blade; rip blade typicallyhas fewer

teeth.