Owner's Manual

4
ASSEMBLY
FIGURE 2
TOOLS REQUIRED FOR ASSEMBLY
(2)1/2"Wrenches
(1)Screwdriver
(1)Pliers
(1)Hammer
• Assembleaxlethroughholesinframetubes.Youmay
needtoslightlyloosenboltsinframetubestomake
theaxlet.Retightenboltsonlyenoughtoattenthe
lock washers.
• Assemblea1/2"atwasher,ashortspacer,along
spacer,awheel,andanother1/2"atwasheronto
theaxle.Lightlytapapalnutontotheendoftheaxle.
Repeatonotherendofaxle.
1/2" FLAT
WASHER
LONG SPACER
AXLE
PALNUT
SHORT SPACER
• Attachmountingplatestoframetubesusingfour5/16
x1-3/4"hexbolts,3/8"washers,thickwashersplaced
betweenthemountingplatesandframetubes,3/8"
washers,and5/16"nylocknuts.Tightenthebolts.
FIGURE 1
3/8" WASHER
3/8" WASHER
5/16 x 1-3/4" HEX BOLT
THICK
WASHER
5/16"
NYLOCK
NUT
FIGURE 3
• Assembleahitcharmtotheinsideofaframetube
underneaththetank.Usetwo5/16"x2"hexboltsand
5/16"nylocknutsasshowningure3.Do not tighten
yet. Repeat for other side.
5/16" x 2"
HEX BOLT
5/16" NYLOCK NUT
HITCH ARM