Owner's Manual

5
• Assembleboombarstoboommountbracketusing
two5/16"x1-1/4"carriagebolts,toothlockwashers
(betweenbarandbracket),5/16"atwashersand
knobs.Boomconnectinghoseshouldextendupward.
NOTE: Makesurenozzleopeningsfacestraightdown
whenboombarsareinthehorizontaloperatingposition.
FIGURE 4
FIGURE 5
• Fastenendsofhitcharmstogetherusingtwo5/16"x
1-1/4"hexboltsand5/16"nylocknuts.Do not tighten yet.
• Assemblehitchbracketstohitcharmsusingtwo5/16"
x2"hexboltsand5/16"nylocknuts.Positioneachbolt
behindoneofthecrossboltsinthehitcharms.Do
not tighten yet.
• Atthistimetighten all boltsstartingwiththeboltsin
gure3,thentheboltsingure4.
5/16" NYLOCK NUT
BOOM MOUNT BRACKET
5/16" x 2"
HEX BOLT
• Assembleboommountbrackettorearofhitchtubes
usingtwo5/16"x2"hexboltsand5/16"nylocknuts.
5/16" x 2"
HEX BOLT
5/16" NYLOCK NUT
5/16" x 1-1/4"
HEX BOLT
5/16" NYLOCK NUT
FIGURE 6
FIGURE 7
• Assemblelargeandsmallspraygunclipstosideof
tankusingtwo#10x1/2"screwsand#10lockwashers.
SPRAY GUN
CLIP (LARGE)
SPRAY GUN
CLIP (SMALL)
#10 x 1/2"
SCREW
#10 LOCK
WASHER
CARRIAGE BOLT
5/16" x 1-1/4"
KNOB
5/16" WASHER
WASHER
(TOOTH LOCK)
BOOM BAR
BOOM CONNECTING HOSE