Operator's Manual M 2-Cycle WEEDWACKER® GAS TRIMMER Model No. 316.711471 UNBELIEVABLE STARTING E A S E _= ,, SAFETY * ASSEMBLY * OPERATION CAUTION: Before using this product, read this manual and follow all its Safety Rules and Operating instructions. Sears Brands Management * PARTS LIST * ESPANOL, R 19 Corporation, Visit our website: 769-08434 / 01 * MAINTENANCE Hoffman Estates, IL 60179 U.S.A. www.craftsrnan.
TABLEOFCONTENTS Safety............................................... 2 Warranty............................................. 5 KnowYourUnit........................................ 6 Specifications ......................................... 6 Assembly ............................................. 7 OilandFuel........................................... 8 Starting andStopping ................................... 9 Operation ............................................ 10 Maintenance ............................
• iMPORTANT SAFETY iNSTRUCTiONS READ ALL iNSTRUCTiONS BEFORE OPERATING WHILE OPERATING Wear safety glasses or goggles that meet ANSI Z87.1 standards and are marked as such. Wear ear/hearing protection when operating this unit. Wear a face or dust mask if the operation is dusty. Wear heavy long pants, boots, gloves and a long sleeve shirt. Do not wear loose clothing, jewelry, short pants, sandals or go barefoot. Secure hair above shoulder level.
OTHER SAFETY WARNINGS Never store the unit with fuel in the tank, inside a building where fumes may reach an open flame (pilot lights, etc.) or sparks (switches, electrical motors, etc.). Store the unit in a dry place, secured or at a height to prevent unauthorized use or damage. Keep the unit out of the reach of children. ,i, All service, other than the maintenance procedures described in this manual, should be performed by a Sears or other qualified service dealer.
CRAFTSMAN TWO YEAR FULL WARRANTY FOR TWO YEARS from the date of purchase, this product is warranted will receive free repair or replacement if repair is unavailable. ADDITIONAL LIMITED WARRANTY on TRIMMER against any defects in material or workmanship. A defective product SHAFT FOR THE THIRD THROUGH TENTH YEAR from the date of purchase, the outer metal housing of the trimmer shaft is warranted against any defects in material or workmanship.
APPLiCATiONS Asatrimmer: • Cutting grassandlightweeds. Edging Decorative trimming around trees,fences, etc. Otheroptional accessories maybeusedwiththisunit. Muffler Spark Plug Starter Rope Grip _, Choke Lever Shaft Grip ASSEMBLY TOOLS = • REQUIRED: #2 Phillips screwdriver 3/8" Socket On/Off Handle Fuel Cap Throttle Control Shaft Housing Primer Bulb Cutting Head Shield Cutting Head Line Cutting Blade Engine Type ..................................................................................
iNSTALLiNG THE CUTTING HEAD SHIELD _ operate the unitTowithout cuttingpersonal head shield place. WARNING: preventthe serious injury,innever _ ] Cutting Head Shield \ \ Use the following instructions if the cutting head shield is not installed. Use only the instructions that apply to the type of shaft and shield equipped with this unit. 1. Place the cutting head shield onto the mount bracket. Align the holes in the cutting head shield with the holes in the mount bracket. (Fig. 1) 2.
FUELING THE UNiT OiL AND FUEL MiXiNG iNSTRUCTiONS The use of old and/or improperly mixed fuel is the most common cause of performance problems. Use only fresh, clean unleaded gasoline. Follow the instructions carefully for the proper gasoline/oil mixture. WARNING: Gasoline is extremely flammable, ignited vapors may explode. Always stop the engine and allow it to cool before filling the fuel tank. Do not smoke while filling the tank. Keep sparks and open flames at a distance from the area.
I_ Off (O) / Stop ! outdoor area. Carbon monoxide exhaust fumes can be I WARNING: lethal in a confined Operate area.this unit only in a well-ventilated serious injury, the operator and the unit must be in a stable WARNING: starting position when Avoid pulling accidentally the starter rope (Fig.the 5). unit. To avoid STARTING J INSTRUCTIONS 1. Mix gasoline with oil. Refer to Oil and Fuel Mixing Instructions. 2. Fill the fuel tank. Refer to Fueling the Unit. NOTE: There is no need to turn the unit on.
HOLDINGTHE _ • TRIMMER J body protection to reduce the risk of injury when operating WARNING: Always wear eye, hearing, hand, foot and i this unit. Stand in the operating position (Fig. 6). Hold the shaft grip with the right hand. Keep the right arm slightly bent. Hold the handle with the left hand. Keep the left arm straight. Hold the unit at waist level. ,_ Keep the cutting head parallel to the ground so that it easily contacts the grass without the need for bending over.
WARNING: To prevent serious injury, never perform maintenance or repairs while the unit is running. Always allow the unit to cool before servicing or repairing the unit. Disconnect the spark plug wire to prevent the unit from starting accidentally. MAINTENANCE Outer / / Fig.9 NOTE: Maintenance, replacement, or repair of the emission control devices and system may be performed by a Sears or other qualified service dealer. Call 1=800-4-MY-HOME for more information.
Part 2 - Winding = • New Trimming Line onto the inner Reel If using single line, refer to Winding Single Line. If using split line, refer to Winding Split Line. If using a prewound inner reel, proceed to Part 3 - Installing the Inner Reel. Winding Split Wall Single Line 1. Cut one 12-foot (3.7 m) length of new single trimming line. Fold the line in half to create a loop in the middle. 2. Insert the loop into the slot in the split wall (Fig. 12).
MAiNTAiNiNG THE AiR FILTER Air Filter J the engine and allow it to cool before cleaning or maintaining To avoid serious personal injury, always stop | WARNING: the unit. Failure to maintain the air filter can result in poor performance or can cause permanent damage to the engine. Engine failure due to improper air filter maintenance is not covered by the product warranty. Cleaning \ Lock Tab the Air Filter 1.
MAiNTAiNiNG THE SPARK PLUG 1. Stop the engine and allow it to cool. Grasp the spark plug boot firmly and pull it from the spark plug. 2. Clean around the spark plug. Remove the spark plug from the cylinder head with a 5/8-inch socket, turning counterclockwise. \ | _ electrodes. GritDo in not the sand engine could damage the cylinder. WARNING: blast, scrape or clean spark plug J 3. inspect the spark plug.
CLEANING STO RAG E • the engine and allow it to cool before cleaning or maintaining To avoid serious personal injury, always stop WARNING" the unit. ] Use a small brush to clean the outside of the unit. Do not use strong detergents. Household cleaners that contain aromatic oils such as pine and lemon, and solvents such as kerosene, can damage plastic. Wipe off any moisture with a soft cloth. Never store a fueled unit where fumes may reach an open flame or spark.
PROBLEM SOLUTION The primer bulb was not pressed enough Press the primer bulb 10 times or until fuel is visible The fuel is old (over 30 days) and/or improperly mixed Drain the fuel tank and add fresh, properly mixed fuel The fuel is old (over 30 days) and/or improperly mixed Drain the fuel tank and add fresh, properly mixed fuel The fuel is old (over 30 days) and/or improperly mixed Drain the fuel tank and add fresh, properly mixed fuel The air filter is dirty Clean or replace the air filter Th
Congratulations on making a smart purchase. Your new Craftsman@ product is designed and manufactured for years of dependable operation. But like all products, it may require repair from time to time. That's when having a Repair Protection Agreement can save you money and aggravation.
REPLACEMENT PARTS - MODEL 316.711471 2-CYCLE GAS TRIMMER % item Part No. Description Part No.
REPLACEMENT item Part No.
Your Home product manuals and expert advice: For troubleshooting, managemylife www.managernylife.com For repair - in your home - of all major brand appliances, lawn and garden equipment, or heating and cooling systems, no matter who made it, no matter who sold it! For the replacement parts, accessories and owner's manuals that you need to do-it-yourself. For Sears professional installation of home appliances and items like garage door openers and water heaters.