Operator`s manual
OIL AND FUEL SAFETY • Avoid accidental starting. Be in the starting position whenever pulling the
m i_ ARNING: Gasoline is highly flammable and its vapors can
explode if ignited. Take the following precautions:
• Store fuel only in containers specifically designed and approved for the
storage of such materials.
• Always stop the engine and allow it to cool before filling the fuel tank. Never
remove the fuel tank cap or add fuel when the engine is hot. Never operate the
unit without the fuel cap securely in place.
• Always mix or add fuel in a clean, well-ventilated outdoor area where there are
no sparks or flames. Do not smoke.
• Never Operate the unit without the fuel cap securely in place.
Avoid creating a source of ignition for spilled fuel. Wipe up any spilled fuel
from the unit immediately before starting the unbit. Move the unit at least 30
fett (9.1 m) from the fueling source and site before starting the unit. Do not
smoke.
• Never start or run the unit inside a closed room or building. Breathing exhaust
fumes can be fatal. Operate this unit only in a well-ventilated outdoor area.
• Check the unit for fuel leaks.
Loosen the fuel tank cap slowly to relieve any pressure in the tank.
• Never store the unit with fuel in the tank, inside a building where fumes may
reach an open flame (pilot lights, etc.) or sparks (switches, electrical motors, etc.).
To reduce fire hazard, replace a faulty muffler and spark arrestor. Keep the
engine and muffler free from grass, leaves, excessive grease or carbon build up.
starter rope. The operator and unit must be in a stable position while starting.
Refer to Starting/Stopping Instructions.
Do not touch the engine, gear housing or muffler. These parts get extremely
hot from operation, even after the unit is turned off.
This unit has a clutch. The unit attachment remains stationary when the engine
is idling. If it does not, take the unit to a Sears or other qualified service dealer
for an adjustment.
Turn the engine to off and disconnect the spark plug for maintenance or repair.
TRIMMER SAFETY
The trimmer attachment shield must always be in place while operating the
unit. Do not operate unit without both trimming lines extended, and the proper
line installed. Do not extend the trimming line beyond the length of the shield.
Adjust the D-handle that provides the best possible grip.
Be sure the trimmer attachment is not in contact with anything before starting
the unit.
Use only 0.095 in. (2.41 mm) diameter replacement line. Never use metal-
reinforced line, wire, chain or rope. These can break off and become
dangerous projectiles.
Keep unit clean of vegetation and other materials. They may become lodged
between the trimmer attachment and shield.
Keep hands, face, and feet away from all moving parts. Do not touch or try to
stop the trimmer attachment when it rotates.
SAVETHESEINSTRUCTIONS
,, SAFETY & INTERNATIONAL SYMBOLS ,,
This operator's manual describes safety and international symbols and pictographs that may appear on this product. Read the operator's manual for
complete safety, assembly, operating and maintenance and repair information.
SYMBOLSYMBOL MEANING
W/
:::::_:ev!
I
|
i
3