Datasheet

Electronic Components
Tel. +41-71-370 01 15 MS-CC-Mounting-E-060918.doc Crameda Intersys AG
Kirchstrasse 22
CH-9113 Degersheim ยท Schweiz
End brackets, mounting accessories and block assembly of
Thumbwheel Switches Multiswitch and 7-Segment LED Displays
Codicount
Mounting instructions:
The individual switch modules (1) are arranged into switch assemblies.
These are completed by two end brackets (6) and held together with two or four threaded rods (7) and slotted nuts (8).
Switch types for front mounting are secured by retaining springs. Switch types for rear mounting are inserted into the front panel
cut-out from behind and secured by four screws.
1 Codicount
2 Multiswitch
3 Blank spacing module
4 Ribbed division module
5 Pair of division plates
6 Guide sleeves to division plate are included
7 End brackets
8 Threaded rods
Mounting example
For Multiswitch ranges A, B, G and W and Codicount series 900 4 threaded rods M 2,5 and slotted nuts M 2,5 are required.
For Multiswitch ranges H, L, M, P, R and S and Codicount series 200, 500 and 800 2 threaded rods M 2 and slotted nuts M
2 are required
Threaded rods of size M 2.5 and M 2 with a continuous thread are available on special request.
The following Multiswitch series are an exception:
Multiswitch series D, U, V and Z and Codicount series 100
and 300 switches are assembled by simply pressing them
together. No threaded rods or nuts are required.
Fax +41-71-370 01 16 Page : 1
http://www.crameda.com
Block assembly of water proofed Multiswitch range Q is
achieved by means of rubber gaskets and metal clamps.
Based on customer specification, Crameda Intersys AG provides block assembly of switches as a "ready to install" service.

Summary of content (2 pages)