Silicone Profiling Kit 5 5 forming tools + guiding aid, 16 profile shapes.
This Profiling Toolkit helps to achieve clean profiles and provides for a permanent seal. A releasing agent (soapy water) is not needed to apply the soft caulking mass (silicone). This process results in better adhesion and prevents mould from forming underneath. In the event that the profile application is not perfect, it is possible to redo isolated parts without removing the entire profile.
Important: Always only use the smooth edge for spreading. Regard the spreading-direction! Start again behind the position at which you stopped with a new line section. Bridging across a vertical grout: Orange tool with guides: To cross one-sided grout lines, push the sliding piece diagonally to the profiling tool into the guides provided. Blue tool: If you hold the profiling tool at a slight angle, you cross over the grout-line and doing so you will keep a uniform grout-pattern profile.
Intersection: Orange tool with guides: To cross over intersecting grout lines, push both sliding pieces diagonally into the designated guides. Blue tool: Cover one grout with masking tape. This way, you can cross over the other one. Cleaning of tools: Wipe the excess sealant off with household paper towel. Should this be forgotten, simply rub the tool across a rubber-like surface. Removal of old grouts: Remove old caulking carefully with a caulking removal knife with saw blade.