Use and Care Manual

ManualsBrandsCRANACH ManualsBathDouble Handles 3-Spray 10 in. Wall Mount Shower Head Tub and Shower Faucet 2.5 GPM in Brushed Nickel(Valve Included)

IAPMO Research and Testing, Inc. is a product certification body which tests and inspects samples taken from the supplier's stock or from the market or a

combination of both to verify compliance to the requirements of applicable codes and standards. This activity is coupled with periodic surveillance of the

supplier's factory and warehouses as well as the assessment of the supplier's Quality Assurance System. This listing is subject to the conditions set forth in

the characteristics below and is not to be construed as any recommendation, assurance or guarantee by IAPMO Research and Testing, Inc. of the product

acceptance by Authorities Having Jurisdiction.

This listing period is based upon the last date of the month indicated on the Effective Date and Void After Date shown above. Any change in material,

manufacturing process, marking or design without having first obtained the approval of the Product Certification Committee, or any evidence of

non-compliance with applicable codes and standards or of inferior workmanship, may be deemed sufficient cause for revocation of this listing.

Production of or reference to this form for advertising purposes may be made only by specific written permission of IAPMO Research and Testing, Inc.

Any alteration of this certificate could be grounds for revocation of the listing. This document shall be reproduced in its entirety.

This certificate is not evidence of current listing. To verify listing status, visit the IAPMO R&T

Product Listing Directory at pld.iapmo.org

Effective Date: March 2019 -Rev. 1/22/2020- Void After: March 2024

Product: Plumbing Fixture Fittings - Components File No. MC-8435

Issued To: Hain Yo Enterprises Co., Ltd

No. 102, Tien Tung Rd.

Hemei Township

Changhua, R.O.C. 508

Taiwan

Identification: Each fitting component shall bear permanent legible markings to identify the

manufacturer. This marking shall be the trade name, trademark, or other mark

known to identify the manufacturer. The product shall also bear all other

markings required by the standard. The marking shall be applied so as to be

visible after installation. The product or packaging shall also bear the

cUPC® certification mark along with the term "COMPONENT" above.

Characteristics: Plumbing fixture fitting components to be installed in accordance with the

manufacturer's instructions and the requirements of the latest edition of the

Uniform Plumbing Code.

Products listed on this certificate have been tested by an IAPMO R&T

recognized laboratory. This recognition has been granted based upon the

laboratory's compliance to the applicable requirements of ISO/IEC 17025.

Products are in compliance with the following standard(s):

Summary of content (3 pages)

PAGE 1
IAPMO Research and Testing, Inc. is a product certification body which tests and inspects samples taken from the supplier's stock or from the market or a combination of both to verify compliance to the requirements of applicable codes and standards. This activity is coupled with periodic surveillance of the supplier's factory and warehouses as well as the assessment of the supplier's Quality Assurance System.
PAGE 2
-Rev. 1/22/2020Product: Plumbing Fixture Fittings - Components Issued To: Hain Yo Enterprises Co., Ltd ASME A112.18.1-2018/CSA B125.1-18 Void After: March 2024 File No.
PAGE 3
This certificate is not evidence of current listing. To verify listing status, visit the IAPMO R&T Product Listing Directory at pld.iapmo.org -Rev. 1/22/2020Product: Plumbing Fixture Fittings - Components Issued To: Hain Yo Enterprises Co.