Beverage Dispenser User Manual

Monetary Setup HDC II Programming Guide
6730018 13 July, 2003
SELECT BILL VALIDATOR
1. Press , then press until one of the following is displayed:
2. Press to choose the desired option.
3. Proceed to "Select Monetary Options", PAGE 15, to customize your bill
validator choice.
NOTE
Depending upon your choice of bill validator, some choices
may not display.
4. CONTINUE.
-
No bills will be accepted or there is no bill validator
installed (you can exit the function).
- The pulse bill validator will accept $1 bills.
-
The serial bill validator is selected and will accept $1, $2,
$5, $10, and $20 bills. Use BILL SELECTION METHOD
below to change the bills that will be accepted.
-
A standard MDB bill validator is selected. It will accept
$1, $2, $5, $10 and $20 bills. Use BILL SELECTION
METHOD below to change the bills that will be accepted.
BILL SELECTION METHOD:
The standard $1, $2, $5, $10 and $20 bills are enabled by
pressing the 1, 2, 5, 6, or 7 key(s), respectively, to display
which bill(s) will be accepted.
<
*
>
-
An MDB bill validator that accepts coupons or non-stan-
dard bills (normally used for non-U.S. currency) is con-
nected and operating. Press to enter list of bills.
See BILL LIST OPERATION. See INITIAL SETUP OF
NON-STANDARD BILL VALIDATOR.