Beverage Dispenser User Manual

HDC II Programming Guide Set up a Hot Drink
July, 2003 36 6730018
EUROPEAN CAPPUCCINO
Introducing a great new blended drink called EUROPEAN CAPPUCCINO:
First, a portion of cappuccino topping mix (or lightener) is dispensed, then lay
-
ered on top is a small serving of strong coffee.
1. Replace product in the soup (or international coffee) canister with the light-
ener or cappuccino topping mix.
2. Press . The display shows: . You must enter the four-
digit supervisor code within 6 seconds to gain access.
NOTE
A new machine has a factory-set supervisor code of 0000.
When you have entered the right code, you will hear two beeps and see
in the display. Press .
3. Reconfigure the machine:
a. Press , then press until the display shows - .
b. is the current configuration code, where W = the machine type, X
= 6th product configuration, Y = brewer configuration, and Z = canister
mapping.
See “Set the Machine Type and Configuration Code (Supervi-
sor Mode Only)” on page 20. You will be changing the number repre-
sented by X. The only way to do that is to change all four numbers, so
at this time write down your configuration code so you will know where
to start if you make a mistake.
c. Replace "X" as follows:
For example: If your current configuration code is , you will enter the
numbers
. Your new drink will be selected with the H key. Valid selec-
tions are H3 (black) and H4 (with sugar). After the reconfiguration, timers for
the topping mix or lightener are under the H selection as
, and the timers for
the coffee serving are under the H selection. Now, you need to alter the water
throw times for the two selections. Consult
Table W1 on page 32 for suggestions
for a starting point for your new drink.
If your current value of X is: Change it to:
1 5
2 6
3 7
4 8