User's Manual

VN2000 Bill Acceptor Combo
Front, Side & Contactless Bezel
Kit Installation Guide
General Information
The combo bezel kit has been designed to add a credit cards reader to a Series 2000 bill
acceptors.
The combo bezel replaces the compact bezel.
To remove the compact bezel:
1. Remove four phillips screws (A) located on the front of the
bill acceptor. Remove the bezel and mounting plate.
Combo bezel installation
2. Place the combo bezel on the bill acceptor and install the four screws.
Be cautious not to pinch or damage the bezel cable when installing the combo bezel.
Front Swipe Side Swipe Contactless
Contact our Technical Support @ 1-800-345-8172 with any questions.
Notes:
1) FCC ID: QP8MEICARD
2) CAUTION: changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
3) This device complies with part 15 of the FCC rules. Operation is subject to the following two
conditions: (a) This device may not cause harmful interference, and (b) this device must accept any
interference received, including interference that may cause undesired operation.
©
2007 MEI Inc. Part # 250054258
wwwmeigroup.com Revision G2
*See notes 1 to 3
below
VN2000 Bill Acceptor Combo
Front, Side & Contactless Bezel
Kit Installation Guide
General Information
The combo bezel kit has been designed to add a credit cards reader to a Series 2000 bill
acceptors.
The combo bezel replaces the compact bezel.
To remove the compact bezel:
1. Remove four phillips screws (A) located on the front of the
bill acceptor. Remove the bezel and mounting plate.
Combo bezel installation
2. Place the combo bezel on the bill acceptor and install the four screws.
Be cautious not to pinch or damage the bezel cable when installing the combo bezel.
Front Swipe Side Swipe Contactless
Contact our Technical Support @ 1-800-345-8172 with any questions.
Notes:
1) FCC ID: QP8MEICARD
2) CAUTION: changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
3) This device complies with part 15 of the FCC rules. Operation is subject to the following two
conditions: (a) This device may not cause harmful interference, and (b) this device must accept any
interference received, including interference that may cause undesired operation.
©
2007 MEI Inc. Part # 250054258
wwwmeigroup.com Revision G2
*See notes 1 to 3
below