Install Guide

CPI
G7 Smart 7 Install Guide
G7 Smart 7 Install Guide EN v1.0.2.docx 9 / 13 01.04.2020
4 Smart 7 Status and Display Messages
The Smart 7 DIS versions provide status- operation- and maintenance information by a list of Display
Messages given in 4.1 while the Smart 7 MBH variants provide basic information via Status LED only.
4.1 Display Messages
The status messages on display will show up as listed below and simultaneously give the corresponding
LED status signals shown in 4.2
Reader ready, Reader starting up Reader not connected
Connected to VMC connection to VMC to VMC
Service mode active,
Reader connected to USB Stick/Cable
4.2 Status LED
The table below lists the corresponding LED signals
Status Messages:
Ready
Red LED blinking 1x with Pause „Startup“
Read LED blinking 2x with Pause „No Connection“ (to VMC or Coinchanger)
Read LED blinking 3x with Pause „No Sale“ or TWN 7 active
Service Mode
Orange LED blinks 2x with Pause “Service Mode”
Red LED lighting, Orange LED blinking 1x with Pause “Config. Udate”
Exceptional Errors
Exception Error-Code
AutoConfig AC WAIT
Reader in AutoConfig WAIT mode (LED red and green alternating)