Use and Care Manual
6
OPERATION & USE
BEFORE USE INSTRUCTIONS:
1. Select a firm, level & flat surface to place the purifier. For proper air flow, locate the
unit at least 3 feet from any wall or furniture.
2. Do not place the purifier in close proximity to electronic devices that are sensitive to
electrical fields.
3. Do not place the unit on metal shelving. Air purifier may be placed on floor,
nightstand, table or desk. Make sure the outlet grill faces away from the nearest wall
or furniture.
4. Make sure the intake and outlet grills are not blocked
5. Plug into grounded 120V outlet. (See Safety Instructions)
OPERATING INSTRUCTIONS:
1. Turn control knob to desired setting
2. Select LOW for whisper quiet operation or use in the
bedroom
3. Select MED to operate the air purifier on a continuous use
4. Select HIGH when high levels of air pollutants are present to
quickly circulate and filter the room air
5. The Air Purifier Power Light will illuminate RED when power is
ON
6. The UV Indicator Light will illuminate BLUE when power is ON.
If the UV Indicator Light does not illuminate blue when the
red power light is on, the UV Light needs to be replaced.
REPLACING THE HEPA FILTER
On average, the HEPA filter needs to be replaced every 3-6 months. Filter life will
depend on air quality and usage.
1. ALWAYS turn off and unplug the air purifier from power outlet before replacing
the filter.
2. Remove each of the filters from the unit by pulling gently toward you.
3. To replace the HEPA Filter, discard the old HEPA filter. DO NOT attempt to clean
the HEPA filter. Place the washable particle filter on the new HEPA filter. Insert
into the unit by sliding it into place.
4. To close the rear door, place bottom door tab into the slot and close the door.
DO NOT force the door to close.
(NOTE: If there is any uneven closure at the bottom of the door, it is not closed
securely. You will need to re-insert the bottom door tab into the slot and close
the door. The door should be evenly flush with the purifier body.)
REPLACEMENT HEPA FILTER SET (HS-1934)
The replacement set includes HEPA filter, particle filter and photocatalyst filter.
Replacements can be purchased online at www.crane-usa.com