Full Product Manual

6
occur.
ASSEMBLY & USE
ALWAYS use fresh cool water when operating the humidifier.
1. Turn Water Tank upside down, unscrew Water Tank Cap
and fill with cool water only.
ALWAYS HOLD WATER TANK WITH TWO HANDS
WHEN FULL.
DO NOT fill water all the way to the rim.
DO NOT use hot water.
DO NOT add any medication, essential oils, salt or vapor
pad to the water tank.
DO NOT pour water into Mist Lid.
2. Screw Water Tank Cap back onto Water Tank and turn the tank over to place on
Humidifier Base, making sure it fits together securely.
Note: Do not attempt to move the humidifier while full Water Tank is placed on the
Humidifier Base. Doing so may cause leakage of water and/or Humidifier Base to
overfill.
3. Plug the power cord into a wall socket and turn on the unit by using the Power
Button. Press 1x for low, 2x for medium, 3x for high and 4x to power off.
4. The Power Indicator Light will illuminate in green indicating that there is enough
water in the Humidifier Base and mist will begin emitting through the Mist Lid.
Note: After 20 seconds, the indicator light will turn off but product will continue to run.
SET THE CORRECT HUMIDITY OUTPUT: Adjust the mist output so the mist rises up to be
absorbed by the room air. If mist drops quickly, use the lower output setting so the mist is
rising up.
5. When the humidifier runs out of water, the Power
Indicator Light will turn red and the mist output
will stop. This is a safety feature to prevent the
humidifier from possibly overheating and
damaging the Nebulizer. Turn the humidifier off
and unplug the unit before removing and
refilling the water tank. When emptying the
base, be sure to pour away from the fan outlet.
VAPOR TRAY: Remove the water tank. Place the Crane Vapor Pads (HS-1950) into the
vapor tray or add essential oils to the vapor tray as desired. Replace the water tank
before running the humidifier.
VAPOR PAD PRECAUTION
 Not recommended for infants under 10 lbs (4.5 kg).