Use and Care Manual

6
HUMIDIFIER FEATURES
Crane’s CLEAN CONTROL Anti-microbial Material is proven to help reduce mold and
bacteria growth up to 99.96% in the humidifier base*
*EMSL Test Report 151305654. Reduction of mold and bacteria is based on independent laboratory
testing. EMSL report 151305654 results are based on the reduction of the bacteria in the humidifier base
with Clean Control material, during continuous use. The humidifier base showed a reduction rate up to
99.96% of Gram Negative – Pseudomonas Aeruginosa after 8 hours.
WARM & COOL MIST
Warm & cool mist humidifiers are equally effective in humidifying the air. Using the
warm mist function heats the water and emits warm mist, while the cool mist will not
drastically affect the room temperature.
ULTRASONIC HUMIDIFIER
This humidifier uses a metal diaphragm vibrating at an ultrasonic frequency, much like
the element in high-frequency stereo speakers, to create mist. An Ultrasonic Humidifier is
whisper quiet and produces a fine mist.
REMOTE CONTROL
This humidifier includes a remote control to operate your device remotely. Simply pull
the small plastic tab before use to activate.
DIGITAL CONTROL PANEL ICONS
ON/OFF SWITCH
Turn the humidifier power on or off by pressing this button.
This button can also be used to reset the humidifier.
TIMER
Press to set the timer (from 1-12 hours). The timer will display at the top
center of the digital display screen.
ION
Press to enrich mist with negative ions to freshen the room air.
MAX-MIN MIST CONTROL
Press the button to change the mist output (Low, Medium or High)
SET HUMIDITY LEVEL
Press to set the humidity level between 45-90% (recommended humidity
is 40-50%). To set humidity to continuous, press the button 11 times and
CO will flash and humidifier will run until manually turned off.
COOL/WARM MIST
Cool mist will automatically start when the humidifier is powered on. To
change to warm mist, press this button and within 15 minutes, warm mist
will activate.