CERAMIC TOWER HEATER FOR THE FOLLOWING MODELS : EE-7588R EE-7588W EE-7588O EE-7588B EE-7588M PLEASE READ AND SAVE ALL INSTRUCTIONS TO ENSURE THE SAFE AND EFFCTIVE USE OF THIS APPLIANCE.
TABLE OF CONTENTS Table of Contents, Heater Models P. 1 Safety Instructions P. 2-3 List of Main Parts, Technical Specifications P. 4 Assembly, Operation and Use P. 5-6 Maintenance, Troubleshooting P. 7 Warranty P. 8 HEATER MODELS This instruction manual applies to the following models of the Ceramic Tower Heater product line: Color Model # Red EE-7588R White EE-7588W Orange EE-7588O Black EE-7588B Mushroom EE-7588M For information about all CRANE products, please visit http://www.
IMPORTANT SAFETY INSTRUCTIONS Always follow basic safety precautions when using electrical products, especially when children are present. WARNING: TO AVOID THE RISK OF ELECTRICAL SHOCK, ALWAYS MAKE SURE THE PRODUCT IS UNPLUGGED FROM THE ELECTRICAL OUTLET BEFORE RELOCATING, SERVICING, OR CLEANING IT. CAUTION: TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF PLUG TO WIDE OUTLET SLOT AND FULLY INSERT. WARNING! READ AND SAVE THESE INSTRUCTIONS.
GENERAL SAFETY INSTRUCTIONS WARNING! Read and understand all instructions. Failure to follow all instructions listed below may result in electric shock, fire or serious personal injury. The warnings, cautions, and instructions discussed in this instruction manual cannot cover all possible conditions and situations that may occur. It must be understood by the user that common sense and caution are a factor which cannot be built into this product, but must be supplied by the user.
LIST OF MAIN PARTS 1. 2. 3. 4. 5.
ASSEMBLY 1. Remove tie from power cord and unravel the power cord. 2. Connect the front base to the rear base by placing attached pegs into the appropriate holes. 3. Slide the power supply cord through the assembled base from the top. (Fig. 1) 4. Position the connected base pieces where the front base piece is facing in the direction of the front grill. 5. Move base so the screw holes align properly.
NOTE: Avoid overloading your circuit by not using other high wattage appliances in the same outlet. Control Knob Oscillating Switch 4. Rotate the control knob to the desired function. OFF Off LO Low heat mode Fan HI High heat mode 5. Turning the Oscillating Switch to the “ON” position will allow the Tower Heater to oscillate left and right. To stop the oscillation, turn the oscillating switch to the “OFF” position. 6.
MAINTENANCE CAUTION: Always be sure that the heater is switched OFF, unplugged and completely cooled before cleaning or attempting to store the item. The Tower Heater takes approximately 15-20 minutes to cool completely. Do not immerse heater in water or allow water to drip into the interior of the heater, as this could create an electric shock hazard. CARE AND CLEANING Allow the product to completely cool before handling, cleaning or storing.
LIMITED WARRANTY Thank you for purchasing a Crane product. This Ceramic Heater was tested and meets our stringent quality standards. This product is warrantied to be free from manufacturing defects under normal use and conditions for 1 year. PLEASE DO NOT RETURN THIS PRODUCT TO THE STORE. CALL US FOR PROBLEMS AND QUESTIONS. WE CAN HELP. If you experience unsatisfactory operation, first refer to the troubleshooting section in the manual to ensure that it is not due to care or cleaning.