About the Crate Acoustic CA60: D esigned for the performing artist, Crate’s CA60 Acoustic Amplifier gives you more of what you want. More power. More clarity. More control. And, more freedom. Imagine: microphone quality sound, without feedback. And without being “chained” to a mic stand! More power: twin 30-watt RMS power amplifiers drive a pair of specially designed high fidelity 6-1/4” transducers for plenty of volume and low end punch.
Crate Acoustic amplifiers are Made With Pride in the U.S.A. To get this amplifier to sound its best, read this owner’s guide prior to its use. Technical Specifications: Output Power Rating: 60 watts RMS total system power Internal Amp: 2 x 30 watts RMS @1% THD Inst. Channel: Low: +/-15dB @ 80Hz To keep this amplifier looking its best, avoid abrasive cleansers. Wipe the cabinet clean using a slightly dampened cloth. Never use brass cleaners on the hardware since they could damage their protective coatings.
On the Front Panel: Instrument Active Input Piezo Shape Gain 0 10 Low Mid High Freq Cut 0 0 0 500Hz -15dB Peak –15 +15 –15 +15 –15 +15 80Hz 4kHz 0 –30dB 0 10 Vocal / Aux Chorus Rev/Eff Send Depth Chorus 0 10 Rate 0 Low-Z Hi-Z Phantom Chorus 10 Gain 0 10 Low High 0 0 –15 +15 –15 +15 Rev/Eff Send 0 10 Rev Return 0 10 Master Level 0 Power 10 Crate Acoustic CA60 1 23 4 5 6 7 8 9 10 11 12 13 14 The Instrument channel: 1: Input.
On the Rear Panel: Effects Loop Line Outputs 0 33: Line Out Level. Use this control to adjust the output level of the line out signal. (This control works independently from the amplifier’s master level control.) Foot Switch Not Shown: Power cord. Connect the end of this cord to a suitable source of line voltage. Refer to the voltage information on the back of the amplifier for its voltage and current requirements. Note: This is a grounded plug.
www.crateamps.com ©1999 SLM Electronics A Division of St. Louis Music Co. 1400 Ferguson Avenue St.