Assembly Instruction

ManualsBrandsCrate & Barrel ManualsAccessoriesCrate & Barrel Alto Leaning Desk

HARDWARE

TOOLS REQUIRED

Phillips head screwdriver

Flat head screwdriver

Electric drill & 5/8" drill bit

(for drywall installation) &

3/16" drill bit (for masonry)

Hammer

1 Lay left and right side rails on a flat surface with

flanges facing each other, oriented as shown. Note the

location of the holes on the flanges to determine the

orientation of the rails.

20 - large screws

2 - small screws

2 - medium screws

2 - wall anchors

2 - toggle bolts

2 - brackets

Thank you for purchasing the Alto Leaning Desk.

This page lists all the contents included in the box.

Please take time to identify the hardware as well as

the individual components of this product. As you

unpack and prepare for assembly, place the

contents on a carpeted or padded area to protect

them from damage.

Note: 2 people are required to safely assemble this

product.

COMPONENTS

2 - side rails

(1 left, 1 right)

1 - top shelf

1 - 2nd shelf

1 - desktop

Page 1 of 3

Made in China - r03

4 - tube caps

ALTO LEANING DESK

Customer Service 800.967.6696 | www.crateandbarrel.com

Missing hardware? Please call 800.606.6387 for replacements.

Bottom

Top

(flanges

are closest

to ends)

RIGHT RAIL

LEFT RAIL

Back

Front

Back

Front

NOTE: You are

assembling the

unit face down.

Summary of content (3 pages)

PAGE 1
ALTO LEANING DESK HARDWARE 2 - small screws 2 - wall anchors 2 - medium screws 2 - toggle bolts 20 - large screws 2 - brackets 4 - tube caps Missing hardware? Please call 800.606.6387 for replacements. TOOLS REQUIRED Thank you for purchasing the Alto Leaning Desk. This page lists all the contents included in the box. Please take time to identify the hardware as well as the individual components of this product.
PAGE 2
ALTO LEANING DESK NOTE: Do not over tighten the screws. Top Shelf (underside) BOTTOM 2 Insert tube caps into ends of both side rails. 3 Verify bottom flanges face each other. Using a phillips head screwdriver, attach top shelf with 4 large screws by passing screws through flange and into shelf's pre-drilled holes. Secure all screws but do not over-tighten.
PAGE 3
ALTO LEANING DESK 6 With the assistance of another adult, position assembled unit against wall in desired location. Verify back edges of shelves all touch the wall as illustrated. Brackets attached to the desktop should also be touching the wall. Mark location of each bracket mounting hole on the wall. Move unit out of workspace. Mounting to masonry wall: Drill a 3/16" diameter hole at the mark. Insert a wall anchor into each hole and gently tap until flush with a hammer.