Assembly Instruction

ARBOR RECTANGULAR DINING TABLE

Thank you for purchasing the Arbor Rectangular

Dining Table. This page

lists all the contents included

in the box. Please take the time

to identify the hardware

as well as the individual components

to this product.

As you unpack and prepare for assembly, place the

contents on a carpeted or padded area to protect them

from damage.

Note: 2 people are required to safely assemble this product.

HARDWARE

TOOLS REQUIRED

COMPONENTS

1 - tabletop

4 - legs

With the assistance of another adult, carefully lay

tabletop upside down onto a clean, padded surface.

Missing hardware?

Please call 800.606.6387 for replacements.

4 - hex nuts

(pre-attached)

4 - spring washers

(pre-attached)

4 - flat washers

(pre-attached)

hex wrench

Made in Bolivia - r07

Page 1 of 2

Customer Service 800.967.6696 | Latest instructions availalbe at www.crateandbarrel.com

1 - umbrella

cap

PAGE 1
ARBOR RECTANGULAR DINING TABLE HARDWARE 4 - hex nuts 4 - flat washers (pre-attached) (pre-attached) 4 - spring washers (pre-attached) Missing hardware? Please call 800.606.6387 for replacements. 1 - umbrella cap Thank you for purchasing the Arbor Rectangular Dining Table. This page lists all the contents included in the box. Please take the time to identify the hardware as well as the individual components to this product.
PAGE 2
ARBOR RECTANGULAR DINING TABLE NOTE: Fit each numbered leg into corresponding number on table top 2 Using a hex wrench, remove pre-assembled 1 flat washer, 1 spring washer and 1 hex nut from each leg. Fit threaded stud of each leg into corresponding hole of tabletop as shown. Make sure to fit each numbered leg into corresponding number on table top 3 Attach each leg with 1 flat washer, 1 spring washer and 1 hex nut. Secure, but do not over tighten, hex nuts with an hex wrench.