Assembly Instruction

ManualsBrandsCrate & Barrel ManualsAccessoriesCrate & Barrel Cubix Black Stackers

Customer Service 800-967-6696 | http://www.crateandbarrel.com

HARDWARE

1 A. Insert 6 cam screws on 1 side of the center panel and 2

cam screws on the other side as shown. Secure each screw

with a phillips head screwdriver, but do not over tighten.

Insert 3 dowels into the holes on the edge as shown.

B. Insert 8 cam screws into the bottom panel and secure with

a screwdriver.

Thank you for purchasing the Cubix Stacker. This

page lists all the contents included in the box.

Please take time to identify the hardware as well as

the individual components of this product. As you

unpack and prepare for assembly, place the contents

on a carpeted or padded area to protect

them from damage.

COMPONENTS

1 - center panel

TOOLS REQUIRED

Phillips head screwdriver

1 - bottom panel

1 - back panel

1 - top panel

CUBIX STACKER

Page 1 of 4

Made in China - r04

Missing hardware? Please call 800.606.6387 for replacements.

22 - cams

22 - cam screws 39 - dowels

22 - cam covers

1 - grommet

1 - short

divider

2 - dividers

with slot

1 - tall divider

Center

Panel

Bottom

Panel

1 - medium

divider

Label

indicates

top edge

Summary of content (4 pages)

PAGE 1
CUBIX STACKER HARDWARE 22 - cams 22 - cam screws 22 - cam covers 39 - dowels 1 - grommet Missing hardware? Please call 800.606.6387 for replacements. Thank you for purchasing the Cubix Stacker. This page lists all the contents included in the box. Please take time to identify the hardware as well as the individual components of this product. As you unpack and prepare for assembly, place the contents on a carpeted or padded area to protect them from damage.
PAGE 2
CUBIX STACKER A B A Arrows on each cam points towards nearest edge Tall Divider B Tall Divider Top Panel 2 A. Insert 4 cam screws into the top panel and secure with a screwdriver. B. Insert 2 cam screws into the tall divider and secure with a screwdriver. Insert 4 dowels into holes in top and bottom edges as shown. Center Panel 3 A. Insert 4 cams into the large holes of the tall divider. Make sure to orient the cams as shown, so that the arrow points towards the nearest edge. B.
PAGE 3
CUBIX STACKER NOTE: At this point decide how you want to configure your Cubix units. Each unit can be assembled in 2 different ways, depending on how you want to orient the units. See page 4 for sample configurations and determine which unit you want to construct. This step is for Assembly Option A. x8 Cam in unlocked position Cam in locked position B A 6 Secure assembly by turning all 8 cams 90º clockwise with a phillips head screwdriver. 7 A.
PAGE 4
CUBIX STACKER CONFIGURATION OPTIONS two units Tw o A A s s e m b l i e s Tw o A A s s e m b l i e s Tw o A A s s e m b l i e s three units B A A Three A Assemblies Tw o A & O n e B A s s e m b l i e s four units B B A Tw o A & Tw o B A s s e m b l i e s Four A Assemblies CLEANING AND CARE Clean surfaces with a dry or damp soft cloth. Do not use abrasive cleaners. NOTE: The Cubix stacking modules are not designed to be used vertically.