Assembly Instruction

HARDWARE

TOOLS REQUIRED

COMPONENTS

Customer Service 800.967.6696 | www.crateandbarrel.com

Made in Vietnam R02 Page 1 of 3

Thank you for purchasing the Ellis Nightstand. This

page lists all the contents included in the box. Please

take time to identify the hardware as well as the individual

components of this product. As you unpack and prepare

for assembly, place the contents on a carpeted or

padded area to protect them from damage.

Note: 2 people are required to safely assemble this product.

ELLIS NIGHTSTAND

Missing hardware?

Please call 800.606.6387 for replacements.

8 - screws

14 - bolts

14 - flat

washers

1 - back panel1 - front frame 1 - left side panel

1 - drawer left

side panel

1 - shelf panel1 - top panel

1 - right side panel

1 - drawer right

side panel

1 - drawer back panel 1 - drawer front panel 1 - drawer bottom panel

14 - spring

washers

Phillips head screwdriver

PAGE 1
ELLIS NIGHTSTAND HARDWARE 14 - bolts 14 - spring washers Thank you for purchasing the Ellis Nightstand. This page lists all the contents included in the box. Please take time to identify the hardware as well as the individual components of this product. As you unpack and prepare for assembly, place the contents on a carpeted or padded area to protect them from damage. 8 - screws 14 - flat washers Missing hardware? Please call 800.606.6387 for replacements.
PAGE 2
ELLIS NIGHTSTAND Make sure the wheels face towards the front. Note: Do not over tighten the bolts. 1 Carefully lay back panel on padded surface. Fit left and right side panel onto back panel by aligning pre-assembled dowels with corresponding holes. Secure with 4 bolts, 4 spring washers, and 4 flat washers. Secure with Phillips head screwdriver but do not over tighten. 2 Fit front frame onto assembled unit as shown by aligning dowels with corresponding holes.
PAGE 3
ELLIS NIGHTSTAND Make sure the wheels of the drawer slides face out and towards the back 4 Attach the drawer left side panel to the drawer front panel and drawer back panel with 4 screws. Secure with a Phillips head screwdriver. 5 Slide drawer bottom panel into the groove at the base of the assembly. 7 Insert drawer assembly into the case, fitting wheels of drawer glide into rail of case glides. Assembly is now complete.