Assembly Instruction

ELLIS WALL MIRROR
HARDWARE
TOOLS REQUIRED
Phillips head screwdriver
Made in Vietnam- r03
Page 1 of 1
2 - screws 2 - plastic anchors
Missing hardware? Please call 800.606.6387 for
replacements.
Thank you for purchasing the Ellis Wall Mirror. This
page lists all the contents included in the box. Please
take time to identify the hardware as well as the
individual components of this product. As you unpack
and prepare for assembly, place the contents on a
carpeted or padded area to protect them from damage.
Note: 2 people are required to safely install this product.
WALL MOUNTING INSTRUCTIONS
Note: The wall mounting hardware included with this mirror is intended for drywall installation only. Be sure to use
hardware appropriate for your wall type. Whenever possible, attach mounting hardware into a wall stud.
If you are unsure about your wall type or what mounting method you should use, consult a qualified professional or your
local hardware store.
1) Determine where you wish to hang the mirror and mark on the wall where the 2 anchors should be inserted.
The distance between the 2 keyhole hanging brackets is 23 11/16". Make sure both marks are level.
2) Drill a pilot hole for each anchor slightly smaller than the diameter of the drywall anchor.
3) Insert 1 drywall anchor into each hole until the head of the anchor is flush with the surface of the wall. Gently tap with
a hammer if necessary.
4) Fasten 1 screw with a phillips head screwdriver into each drywall anchor, leaving approximately 1/4" of the screw
projecting from the face of the wall.
5) With the assistance of another person, hang the mirror on the screw heads. Make sure that each screw head snugly
engages the keyhole bracket fitting.
CLEANING AND CARE
Clean surfaces with a dry or damp soft cloth. Do not use
abrasive cleaners. Use glass cleaner to clean the mirror as necessary.