Assembly Instruction

GRAHM RECTANGULAR MIRROR
HARDWARE
CLEANING AND CARE
Use a slightly damp cloth to wipe the mirror.
Do not use furniture polish on the wood frame
as it is finished with a protective lacquer.
Clean mirror with a glass cleaner.
Do not use abrasive cleaners on the mirror or frame.
Made in China - r06
Page 1 of 1
Thank you for purchasing the Grahm Rectangular Mirror.
This page lists all the contents included in the box.
Please take time to identify the hardware as well as the
individual components of this product. As you unpack and
prepare for assembly, place the contents on a carpeted or
padded area to protect them from damage.
1 - screw1 - drywall anchor
HANGING INSTRUCTIONS
Important Note:
The wall mounting hardware included with this mirror is
intended for drywall installation only. Be sure to use
hardware appropriate for your wall type. Whenever possible,
attach mounting hardware into a wall stud. If you are unsure
about your wall type or what mounting method you should
use, consult a qualified professional or your local hardware
store.
CAUTION: Use extreme caution when hanging heavy objects
on the wall. Improper anchoring may result in serious injury.
A. Determine wall location and drill a pilot hole approximately
1/8"diameter. Insert a drywall anchor into the hole and
secure with a phillips head screwdriver. Fully tighten until
the anchor is seated flush with the surface of the wall. NOTE:
If mounting directly into a wall stud, do not use the wall anchor
but fasten screw directly into the wall stud.
B. Insert the screw with a screwdriver into the anchor and
leave 3/16" protruding out from the surface of the wall.
C. With the assistance of another adult, hang the mirror by the
cable attached to the back of the frame.
OPTIONAL PORTRAIT HANGING
Follow Steps A and B outlined above.
On mirror back, remove bolts and washers with the a llen
wrench. Re-attach cable assembly to the alternate holes on
the back of the mirror frame as shown and hang mirror.
Installation is now complete.
Missing hardware?
Please call 800.606.6387 for replacements.
hanging
wire
1 - short
hanging wire
1 - long
hanging wire
4 - washers
landscape
portrait
Customer Service 800.967.6696 | www.crateandbarrel.com
screw
washer
hanging
wire
washer
Depending on the desired orientation, attach
either the short or long hanging wire to back
of mirror with 2 screws and 4 washers as
shown. Secure screws with a phillips head
screwdriver.
HANGING INSTRUCTIONS
Important Note:
The wall mounting hardware included with this mirror is intended
for drywall installation only. Be sure to use hardware
appropriate for your wall type. Whenever possible, attach
mounting hardware into a wall stud. If you are unsure about your
wall type or what mounting method you should use, consult a
qualified professional or your local hardware store.
CAUTION: Use extreme caution when hanging heavy objects
on the wall. Improper anchoring may result in serious injury.
A. Determine wall location and drill a pilot hole approximately
1/8"diameter. Insert a drywall anchor into the hole and secure
with a phillips head screwdriver. Fully tighten until the anchor is
seated flush with the surface of the wall. NOTE: If mounting
directly into a wall stud, do not use the wall anchor but fasten
screw directly into the wall stud.
B. Insert the screw with a screwdriver into the anchor and leave
3/16" protruding out from the surface of the wall.
C. With the assistance of another adult, hang the mirror by the
cable attached to the back of the frame.
OPTIONAL DIAGONAL HANGING
Follow Steps A and B outlined above.
On mirror back, remove bolts and washers with the a llen wrench.
Re-attach cable assembly to the alternate holes on the back of
the mirror frame as shown and hang mirror.
Installation is now complete.
pre-installed hanging wire
A
B
C
TOOLS REQUIRED
Phillips head screwdriver Allen Wrench (included)