Assembly Instruction

ManualsBrandsCrate & Barrel ManualsTablesCrate & Barrel Loop Nightstand

HARDWARE

TOOLS REQUIRED

COMPONENTS

Made in China - r11 Page 1 of 4

Thank you for purchasing the Loop Nightstand. This

page lists all the contents included in the box. Please

take time to identify the hardware as well as the individual

components of this product. As you unpack and prepare

for assembly, place the contents on a carpeted or

padded area to protect them from damage.

LOOP NIGHTSTAND

Missing hardware? Please call 800.606.6387 for replacements.

16 - cam

screws

2- silver

screws

2 - black

screws

18 - wood

dowels

16 - cam

covers

16 - cams

1 - pull4 - glide

screws

Phillips Head Screwdriver

Customer Service 800.967.6696 | www.crateandbarrel.com

1 - top panel

1 - shelf

2 - side frames

(1 left, 1 right

1 - crossbar

1 - drawer front

1 - back panel

1 - drawer back

2 - drawer sides

(1 right, 1 left)

1 - drawer bottom

Summary of content (4 pages)

PAGE 1
LOOP NIGHTSTAND HARDWARE 16 - cams 18 - wood dowels 16 - cam screws 16 - cam covers 2- silver screws 4 - glide screws 2 - black screws 1 - pull Missing hardware? Please call 800.606.6387 for replacements. Thank you for purchasing the Loop Nightstand. This page lists all the contents included in the box. Please take time to identify the hardware as well as the individual components of this product.
PAGE 2
LOOP NIGHTSTAND Arrow on each cam points towards edge with holes A B A Back Panel B Shelf C 1 A) Place left side panel face down on a padded surface. Insert 5 cam screws into the holes as shown. Secure, but do not over tighten with a phillips head screwdriver. B) Insert 2 cams into the large holes as shown, making sure the arrow on each cam points towards the nearest edge with holes. C) Insert 2 wood dowels into the holes as shown. Press firmly to secure. Repeat Steps A & B for the right side panel.
PAGE 3
LOOP NIGHTSTAND 5 Fit the crossbar onto cam screw of the side panel as shown. Secure the cam by turning clockwise with a phillips head screwdriver. 6 Fit cam screws of right side panel into corresponding holes in the assembly. Secure each cam with a phillips head screwdriver. A B 7 A) Insert 6 cam screws into the underside of the top panel. B) Place assembly upright. Fit top panel onto dowels of the assembly and secure each cam with a phillips head screwdriver.
PAGE 4
LOOP NIGHTSTAND These holes at back 9 Slide drawer back into vertical slots at rear of drawer sides. 10 Slide drawer bottom into slot at base of drawer sides and drawer front. Make sure pilot holes are at the back of the drawer bottom as shown. C A B B B A 11 A) Secure underside of drawer bottom to drawer back with 2 black screws. Secure, but do not over tighten with the phillips head screwdriver. B) Fit drawer pull into position as shown and secure with 2 silver screws.