Assembly Instruction

Customer Service 800-967-6696 | http://www.crateandbarrel.com
HARDWARE
Thank you for purchasing the Onyx 30"
Square Mirror. This page lists all the contents
included in the box. Please take time to
identify the hardware as well as the individual
components of this product. As you unpack
and prepare for assembly, place the contents
on a carpeted or padded area to protect them
from damage.
Note: 2 people are required to safely hang
this mirror.
TOOLS REQUIRED
Phillips head screwdriver
1A
1B
1C
ONYX 30" SQUARE MIRROR
Made in China - r01 Page 1 of 1
1 A. Determine wall location and drill a
pilot hole approximately 1/8"diameter.
Insert a drywall anchor into the hole and
secure with a phillips head screwdriver.
Fully tighten until the anchor is seated
flush with the surface of the wall. NOTE:
If mounting directly into a wall stud, do
not use the wall anchor but fasten screw
directly into the wall stud.
B. Insert the screw with a screwdriver
into the anchor and leave 3/16"
protruding out from the surface of the
wall.
C. With the assistance of another adult,
hang the mirror by the cable attached to
the back of the frame.
Missing hardware? Please call 800.606.6387 for
replacements.
1 - drywall anchor 1 - screw
CLEANING AND CARE
WALL MOUNTING INSTRUCTIONS:
The wall mounting hardware included with this mirror is intended for drywall installation only. Be sure to use hardware
appropriate for your wall type. Whenever possible, attach mounting hardware into a wall stud.
If you are unsure about your wall type or what mounting method you should use, consult a qualified professional or your
local hardware store.
Clean surfaces with a dry or damp soft cloth. Do not use
abrasive cleaners. Do not use furniture wax or polish as the
wood is finished with a protective clear lacquer.