Assembly Instruction

Customer Service 800-967-6696 | http://www.crateandbarrel.com

HARDWARE

1 A. Insert 1 tube cap into the top of each leg.

B. Position 1 leg frame as shown and fit brackets into open

tube ends of the 2 crossbars. Make sure tabs of crossbars

are positioned as shown, flush with the floor.

C. Align holes in brackets with holes in cross bars and loosely

attach with 2 allen head screws. Do not fully tighten screws.

Thank you for purchasing the Parallel Desk. This page

lists all the contents included in the box. Please take

time to identify the hardware as well as the individual

components of this product. As you unpack and prepare

for assembly, place the contents on a carpeted or padded

area to protect them from damage.

Note: 2 people are required to safely assemble this

product.

COMPONENTS

2 - leg frames

1 - table top

2 - crossbars

TOOLS REQUIRED

Allen wrench (included)

Phillips head screwdriver

Hammer

x 2

Tabs flush

to floor

PARALLEL DESK

Page 1 of 2

Made in China - r05

Missing hardware? Please call 800.606.6387 for

replacements.

6 - wood screws

6 - washers

8 - allen head screws

8 - tube caps

PAGE 1
PARALLEL DESK HARDWARE 8 - allen head screws 6 - wood screws 6 - washers 8 - tube caps Missing hardware? Please call 800.606.6387 for replacements. TOOLS REQUIRED Thank you for purchasing the Parallel Desk. This page lists all the contents included in the box. Please take time to identify the hardware as well as the individual components of this product. As you unpack and prepare for assembly, place the contents on a carpeted or padded area to protect them from damage.
PAGE 2
PARALLEL DESK B x2 A 2 A. Insert 1 tube cap into the top of each leg in the remaining leg frame. B. Attach leg frame using same method as in Step 1. Secure each crossbar with 2 allen head screws. Do not fully tighten screws. 3 Position frame assembly onto table top, aligning holes in tabs with pre-drilled holes in table top. Using a phillips head screwdriver, secure each tab with 1 wood screw and 1 washer. x8 5 At this point, fully tighten all 8 allen head screws with the allen wrench.