Assembly Instruction

Thank you for purchasing
the Viewpoint Low
Office Chair. This page
lists all the contents
included in the box.
Please take time to
identify the hardware as
well as the individual
components of this
product. As you unpack
and prepare for
assembly, place the
contents on a carpeted
or padded area to
protect
them from damage.
VIEWPOINT LOW OFFICE CHAIR
Customer Service 800.967.6696 | www.crateandbarrel.com
Page 1 of 1
Made in China - r02
HARDWARE & TOOLS REQUIRED
1 - allen wrench (included)
4 - bolts
SEAT ADJUSTMENT
CLEANING AND CARE
Clean surfaces with a dry or damp soft cloth.
Do not use abrasive cleaners.
Missing hardware? Please call 800.606.6387 for
replacements.
1 Align holes in each arm with corresponding holes on the
seat edge. Attach each arm with 2 bolts, fully tightening
each bolt with the allen wrench.
While sitting in the chair, pull the lever up to lower
the seat.
To raise the seat, take your weight off the chair and
pull the lever up.
Adjust the back tension by tightening or loosening
the adjustment knob.
A
B
C
2 A. Fit large end of lift cylinder
into corresponding hole in the
base as shown.
B. Firmly fit the stem of each
caster into corresponding holes in
the underside of the base.
C. Fit top of lift cylinder into
opening at the bottom of the seat
mechanism.
IMPORTANT NOTE:
At this point finalize the
assembly by sitting heavily on
the chair a few times.
This will secure all the
component connections.
Assembly is now complete.

Summary of content (1 pages)