Assembly Instruction

ManualsBrandsCrate & Barrel ManualsAccessoriesCrate & Barrel Walker Desk

Customer Service 800-967-6696 | http://www.crateandbarrel.com

HARDWARE

TOOLS REQUIRED

Allen wrench (included)

Phillips head screwdriver

1 Insert 2 cams into holes on underside of lower cross bar.

Make sure arrows on each cam point out towards the ends

with dowels.

Thank you for purchasing the Walker Desk. This

page lists all the contents included in the box.

Please take time to identify the hardware as well as

the individual components of this product. As you

unpack and prepare for assembly, place the

contents on a carpeted or padded area to protect

them from damage.

Note: 2 people are required to safely assemble this

product.

COMPONENTS

1 - glass top

2 - wire braces

2 - side frames

1 - keyboard

tray

1 - lower cross bar

WALKER DESK

Page 1 of 3

Made in China

2 - short

screws

2 - medium

screws

6 - long

screws

2 - cams 6 - small

washers

2 - cam

screws

6 - spring

washers

2 - spacers

6 - large

washers

1 - upper cross bar

6 - rubber bumpers

Make sure arrows

point out towards

ends

Missing hardware?

Please call

800.606.6387 for

replacements.

Summary of content (3 pages)

PAGE 1
WALKER DESK HARDWARE 2 - short screws 2 - cams Thank you for purchasing the Walker Desk. This page lists all the contents included in the box. Please take time to identify the hardware as well as the individual components of this product. As you unpack and prepare for assembly, place the contents on a carpeted or padded area to protect them from damage. Note: 2 people are required to safely assemble this product.
PAGE 2
WALKER DESK A B A Cams face down B 2 A. Fit keyboard tray into position, aligning dowels with corresponding holes in side frame. Using allen wrench, attach with 3 long screws, 3 spring washers and 3 small washers. B. Insert dowels of top cross bar into corresponding holes in side frame. 3 A. Insert 1 cam screw into lower hole on side frame and tighten with a phillips head screwdriver. B. Place lower cross bar into position, aligning wood dowel and cam screw with corresponding holes.
PAGE 3
WALKER DESK x2 A x2 B x2 6 A. Attach 2 wire braces to the frame. Fasten threaded fitting to the underside of the keyboard drawer with 1 medium screw, 1 large washer and 1 spacer. B. Use 1 short screw and 2 large washers to attach the bottom loop to the base of the side frame. 7 At the top of each wire brace, turn each threaded fitting clockwise until each wire brace is taught. B A CLEANING AND CARE Clean surfaces with a dry or damp soft cloth. Do not use abrasive cleaners.