Instruction manual

2. After you reach “CONF”, push the PGM Button again and use Up

and Down Arrows to navigate until you reach “PRO” in the bottom

display and push the “PGM” button again.

3. The display should now read “FNCT” in the bottom display and “2” in

the top display. You will need to change the “2” to “0”. To do that,

push the “PGM” button once and the “FNCT” should start flashing.

While it is flashing, use the Down Arrow to change the “2” to “0”.

When the “FNCT” stops flashing, push the exit button repeatedly to

return to normal display (Actual Value on Top and Setpoint Value on

Bottom.)

4. Now the control is setup as a Single Setpoint Control. Just use the

Down Arrows to change Setpoint Value.

EXAMPLE PROGRAM

Let’s say you want to have the oven to ramp up to 100°C in 30 minutes

and control for 1 hour at 100°C. Then you want to ramp up to 150° in 30

Minutes and control for 2 hours. Then you want to cool down to start Set

Point with Power Exhaust Outlet activated in one hour. See Graph:

EXAMPLE PROGRAM CHART

100

110

120

130

140

150

160

30 MINUTES INTERVALS

TEMPERATU

100 100

150 150 150 150

You would program the control like this:

STEP1 SP01=25° TPO01=00:30hr OC01-0000

STEP2 SP02=100° TPO02=01:00hr OC02-0000

STEP3 SP03=100° TPO03=00:30hr OC03-0000

STEP4 SP04=150° TPO04=02:00hr OC04-0000

STEP5 SP05=150° TPO05=01:00hr OC05-0100

STEP6 SP06=25° TPO06=00:00hr OC06-0000

The OC parameter 0100 is the value that activates the Exhaust Outlet on

the back of the oven.

To activate the program that is entered first return to normal display by

pushing the Exit Button repeatedly. After Normal Display is

reached, push the up arrow

once. The lower display should flash STrT