Owner`s manual

V100H Tube Guitar Amplifier with Reverb
4
The Front Panel
1. BRIGHT INPUT: Use this jack to con-
nect your guitar to the amplifier using a
shielded instrument cable. It provides a
high-frequency boost compared to the
Normal input for a brighter, punchier
sound.
2. NORMAL INPUT: Use this jack to con-
nect your guitar to the amplifier using a
shielded instrument cable.
CLEAN Channel
3. LEVEL: Use this to adjust the volume of
the Clean channel.
4. TREBLE: Use this to adjust the output
level of the high frequencies. The adjust-
ment range is 12 dB at 6 kHz.
5. MIDDLE: Use this to adjust the output
level of the mid frequencies. The adjust-
ment range is 10 dB at 1 kHz.
6. BASS: Use this to adjust the output
level of the low frequencies. The adjust-
ment range is 8 dB at 150 Hz.
7. CHANNEL Select: Push in this switch
to activate the Overdrive channel. The
Clean channel is active when the switch
is in the out position.
Note: The footswitch also controls this
function.
OVERDRIVE Channel
8. GAIN: Use this to adjust the gain for
the Overdrive channel. With the control
turned counter-clockwise, the gain is
low and very little distortion is present.
As you rotate it clockwise, the gain
increases, producing more overdrive
distortion, and a higher output volume
level.
9. LEVEL: Use this to adjust the output
level of the Overdrive channel.
10. TREBLE: Use this to adjust the output
level of the high frequencies. The adjust-
ment range is 12 dB at 6 kHz.
11. MIDDLE: Use this to adjust the output
level of the mid frequencies. The adjust-
ment range is 10 dB at 1 kHz.
12. BASS: Use this to adjust the output
level of the low frequencies. The adjust-
ment range is 8 dB at 150 Hz.
13. FLAT/VINTAGE: Push this switch in
(Vintage) to give the boost circuit a
punchier sound, with a midrange boost
at 900 Hz. Leave the switch out (Flat)
for the boost control to affect all fre-
quencies.
14. BOOST: This controls the amount of
Flat or Vintage boost that is applied to
the signal. Turn the control clockwise
for more boost.
15. IN/OUT: This turns the boost circuit on
and off. Push the switch IN to turn on
the boost circuit.
Note: The footswitch also controls this
function.
TREBLELEVEL
INPUT INPUT
BRIGHT NORMAL
FLAT/
VINTAGE
IN/OUT
CHANNEL
BASS BOOSTMIDDLE
1
010
2
3
4
5
6
7
8
9
1
010
2
3
4
5
6
7
8
9
1
010
2
3
4
5
6
7
8
9
1
010
2
3
4
5
6
7
8
9
1
010
2
3
4
5
6
7
8
9
1
2
3
GAIN
1
010
2
3
4
5
6
7
8
9
TREBLELEVEL BASSMIDDLE
OVERDRIVE
CLEAN
M
A
1
010
2
3
4
5
6
7
8
9
1
010
2
3
4
5
6
7
8
9
1
010
2
3
4
5
6
7
8
9
1
010
2
3
4
5
6
7
8
9
1 3 42 5 6 7 9 10 11 12 138 14 15