Owner`s manual

V100H Tube Guitar Amplifier with Reverb
5
16. PRESENCE: This controls the overall
brightness and punch of the output sig-
nal.
17. REVERB: Use this to adjust the amount
of reverb. Fully counter-clockwise is
“dry” (no reverb). Rotate clockwise to
increase the amount of reverb.
18. LAMP: This illuminates when the ampli-
fier is turned on.
19. 50W/100W SWITCH: This switch
changes the output power of the ampli-
fier. Using the 50W position gives you a
little less power (–3 dB), but allows you
to get that overdrive sound without the
high volume of the 100W position.
The Front Panel (continued)
TREBLELEVEL
FLAT/
VINTAGE
IN/OUT
CHANNEL
BASS BOOST
POWER100W
MIDDLE
ON50W
STANDBY
ON
1
010
2
3
4
5
6
7
8
9
1
010
2
3
4
5
6
7
8
9
1
010
2
3
4
5
6
7
8
9
1
010
2
3
4
5
6
7
8
9
1
010
2
3
4
5
6
7
8
9
1
010
2
3
4
5
6
7
8
9
1
010
2
3
4
5
6
7
8
9
GAIN
1
010
2
3
4
5
6
7
8
9
PRESENCE
S
OVERDRIVE
MASTER
10
6
7
8
9
REVERB
7 9 10 11 12 138 14 15 16 17 18 19 20 21
20. ON/STANDBY Switch: Use this switch
to activate the amplifier after the On/Off
switch [21] is turned on.
Always turn this switch to STANDBY
first, and ON last! Turn the On/Off
switch [21] on at least 30 seconds
before turning on the Standby switch.
During short breaks, you should turn
this switch to STANDBY, and leave the
On/Off switch on. This will help prolong
the life of the amplifier tubes.
21. ON/OFF SWITCH: Use this switch to
turn the amplifier on and off.
Always turn this switch ON first and OFF
last! Turn the Standby switch [20] on at
least 30 seconds after turning on the
On/Off switch. Turn the Standby switch
to STANDBY before turning off the On/
Off switch.