Specifications
Table Of Contents
- SPA-100 Manual Cover Sheet
- Machine Introduction
- Specifications
- Manual Page
- Diagrams
- Basic Machine Diagram
- Machine and Tester Set-Up
- Machine and Guard Assembly
- Machine Base and Panels Assembly
- Motor and Tool Slide Assembly
- Tool Slide and Punch Holders
- Ram Slide Assembly
- Nest Assembly
- Nest Block Including Nests
- Micro Switch and Nest Stop Assembly
- Punch Holder Assembly (8 Position)
- Cam and Adjustment Assembly
- Test Assembly
- Test Block Assembly - Micro Switch Asseembly
- Controller and Circuits
- Termination Instructions
- Receiving Inspection
- Recommended Spare Tooling and Troubleshooting Tips
- Maintenance for SPA-100
- SPA-100 Parts List
RECEIVING INSPECTION
This machine has been thoroughly inspected before leaving our facility. This
provides the assurance that the machine produces good termination and
Is ready to use. However, the following points should be reviewed to verify that no
problems have occurred during shipment.
1. Carefully uncrate the machine and place it on a sturdy bench and
examine it against the report sent with machine.
2. Inspect the entire machine for evidence of damage that may have
occurred during transit. If in fact the machine shows signs of damage,
contact Sentinel Connector Systems, Inc. immediately.
3. Check all components to be certain they are secure. Don’t operate
machine until all loose tooling has been tightened down safely.
4. Please maintain the crate the machine has been delivered. In the event
the machine has need of repairs or lease if terminated the machine must
be sent back in its original crate. This is to maintain proper protection of
the machine from any shipping damage. Your help in this manner is
greatly appreciated.
5.
8