Specifications

NanoLumens Flexible Display Setup and Operation Manual
14 DMAN-0001 REV B
 Removing any unnecessary brackets or eye bolts (be sure to keep them in a safe
place for later use.)
NOTE: The Flexible Display software connection activity will be completed at the
mounting location. The soft, protective cover may be detached once mounted.
4.2.2 Load into the Shipping Crate
Use these steps after the Flexible Display has been taken down from its mounted
location.
NOTE: The Flexible Display may only be shipped in the crate with the straight hanging
bar attached.
Preparation Checklist
 Refer to Table 1. Components Shipped, column Shipped with Crate, and
Table 2. Required Tools Not Provided.
Prepare the Flexible Display for shipping:
1. Carefully lay the display face-down, flat, on the provided cover and large, debris-
free surface.
2. Remove the installed mounting hardware.
3. If a curved hanging bar is installed, uninstall the curved hanging bar and replace it
with the straight hanging bar. See Section 4.3. Changing Out the Hanging Bar.
NOTE: Prior to loading the Flexible Display into the shipping crate, insert the curved
hanging bar to its shipping position at the base of the crate’s interior foam wall.
4. Add the crate brackets with appropriate hardware in the positions shown, below.
Figure 5. Where to Install the Hanging Brackets on the Hanging Bar