SDS

Precautionary statement
Prevention
Obtain special instructions before use. Do not handle until all safety precautions have been read
and understood. Keep away from heat/sparks/open flames/hot surfaces. - No smoking. Do not
spray on an open flame or other ignition source. Pressurized container: Do not pierce or burn,
even after use. Do not apply while equipment is energized. Extinguish all flames, pilot lights and
heaters. Vapors will accumulate readily and may ignite. Use only with adequate ventilation;
maintain ventilation during use and until all vapors are gone. Open doors and windows or use
other means to ensure a fresh air supply during use and while product is drying. If you experience
any symptoms listed on this label, increase ventilation or leave the area. Avoid breathing mist or
vapor. Wear protective gloves/protective clothing/eye protection/face protection. Wash thoroughly
after handling. Avoid release to the environment.
Response
If swallowed: Immediately call a poison center/doctor. Do NOT induce vomiting. If on skin: Wash
with plenty of water. If skin irritation occurs: Get medical advice/attention. Take off contaminated
clothing and wash before reuse. If inhaled: Remove person to fresh air and keep comfortable for
breathing. Call a poison center/doctor if you feel unwell. If in eyes: Rinse cautiously with water for
several minutes. Remove contact lenses, if present and easy to do. Continue rinsing. If eye
irritation persists: Get medical advice/attention. If exposed or concerned: Get medical
advice/attention. Collect spillage.
Storage
Store in a well-ventilated place. Store locked up. Protect from sunlight. Do not expose to
temperatures exceeding 50°C/122°F. Exposure to high temperature may cause can to burst.
Disposal
Dispose of contents/container in accordance with local/regional/national regulations.
Hazard(s) not otherwise
classified (HNOC)
None known.
3. Composition/information on ingredients
Mixtures
CAS numberCommon name and synonymsChemical name %
107-83-52-methylpentane
30 - 40
68476-86-8liquefied petroleum gas
20 - 30
64742-49-0naphtha (petroleum), hydrotreated
light
10 - 20
8009-03-8petrolatum
5 - 10
110-54-3n-hexane
3 - 5
72623-86-0lubricating oils (petroleum), C15-30,
hydrotreated neutral oil-based
1 - 3
8042-47-5
white mineral oil
1 - 3
Specific chemical identity and/or percentage of composition has been withheld as a trade secret.
4. First-aid measures
Remove victim to fresh air and keep at rest in a position comfortable for breathing. Call a POISON
CENTER or doctor/physician if you feel unwell.
Inhalation
Remove contaminated clothing. Rinse skin with water/shower. If skin irritation occurs: Get medical
advice/attention. Wash contaminated clothing before reuse.
Skin contact
Immediately flush eyes with plenty of water for at least 15 minutes. Remove contact lenses, if
present and easy to do. Continue rinsing. Get medical attention if irritation develops and persists.
Eye contact
Call a physician or poison control center immediately. Rinse mouth. Do not induce vomiting. If
vomiting occurs, keep head low so that stomach content doesn't get into the lungs.
Ingestion
Aspiration may cause pulmonary edema and pneumonitis. May cause drowsiness and dizziness.
Headache. Nausea, vomiting. Irritation of eyes. Exposed individuals may experience eye tearing,
redness, and discomfort. Skin irritation. May cause redness and pain.
Most important
symptoms/effects, acute and
delayed
Provide general supportive measures and treat symptomatically. Keep victim under observation.
Symptoms may be delayed.
Indication of immediate
medical attention and special
treatment needed
IF exposed or concerned: Get medical advice/attention. Ensure that medical personnel are aware
of the material(s) involved, and take precautions to protect themselves. Show this safety data
sheet to the doctor in attendance.
General information
5. Fire-fighting measures
Water fog. Foam. Dry chemical powder. Carbon dioxide (CO2).
Suitable extinguishing media
2 / 10
Material name: Chain Lube
05012 Version #: 02 Revision date: 01-24-2017 Issue date: 02-25-2014
SDS US