MSDS

ManualsBrandsCRC ManualsCable CleanersCable Clean Hf (high Flashpoint)

SAFETY DATA SHEET

1. Identification

Product identifier Cable Clean® HF™ High Voltage Cleaner (High Flash)

Other means of identification

Product code

02170

Recommended use

Splice and termination cleaner for high voltage cables

Recommended restrictions

None known.

Manufacturer/Importer/Supplier/Distributor information

Manufactured or sold by:

Company name

CRC Industries, Inc.

Address

885 Louis Dr.

Warminster, PA 18974 US

Telephone

General Information

215-674-4300

Technical

Assistance

800-521-3168

Customer Service

800-272-4620

24-Hour Emergency

800-424-9300 (US)

(CHEMTREC)

703-527-3887 (International)

Website

www.crcindustries.com

2. Hazard(s) identification

Category 1Flammable aerosols

Physical hazards

Compressed gasGases under pressure

Category 2Skin corrosion/irritation

Health hazards

Category 3 narcotic effectsSpecific target organ toxicity, single exposure

Category 1Aspiration hazard

Not classified.

Environmental hazards

Not classified.

OSHA defined hazards

Label elements

Signal word

Danger

Hazard statement

Extremely flammable aerosol. Contains gas under pressure; may explode if heated. May be fatal if

swallowed and enters airways. Causes skin irritation. May cause drowsiness or dizziness.

Precautionary statement

Prevention

Keep away from heat/sparks/open flames/hot surfaces. - No smoking. Do not spray on an open

flame or other ignition source. Do not apply while equipment is energized. Pressurized container:

Do not pierce or burn, even after use. Extinguish all flames, pilot lights and heaters. Vapors will

accumulate readily and may ignite. Avoid breathing mist or vapor. Use only with adequate

ventilation; maintain ventilation during use and until all vapors are gone. Open doors and windows

or use other means to ensure a fresh air supply during use and while product is drying. If you

experience any symptoms listed on this label, increase ventilation or leave the area. Avoid

breathing gas. Wash thoroughly after handling. Wear protective gloves.

Response

If swallowed: Immediately call a poison center/doctor. Do NOT induce vomiting. If on skin: Wash

with plenty of water. If skin irritation occurs: Get medical attention. Take off contaminated clothing

and wash before reuse. If inhaled: Remove person to fresh air and keep comfortable for

breathing. Call a poison center/doctor if you feel unwell.

Storage

Store in a well-ventilated place. Store locked up. Protect from sunlight. Do not expose to

temperatures exceeding 50°C/122°F. Exposure to high temperature may cause can to burst.

1 / 8

Material name: Cable Clean® HF™ High Voltage Cleaner (High Flash)

1711 Version #: 01 Issue date: 05-19-2014

SDS US

Summary of content (8 pages)

PAGE 1
SAFETY DATA SHEET 1. Identification Product identifier Cable Clean® HF™ High Voltage Cleaner (High Flash) Other means of identification Product code 02170 Recommended use Splice and termination cleaner for high voltage cables Recommended restrictions None known. Manufacturer/Importer/Supplier/Distributor information Manufactured or sold by: Company name Address Telephone General Information Technical Assistance Customer Service 24-Hour Emergency (CHEMTREC) Website CRC Industries, Inc.
PAGE 2
Disposal Hazard(s) not otherwise classified (HNOC) Dispose of contents/container in accordance with local/regional/national regulations. None known. 3. Composition/information on ingredients Mixtures Chemical name Common name and synonyms Distillates (petroleum), hydrotreated light Carbon dioxide CAS number % 64742-47-8 90 - 100 124-38-9 1-3 Specific chemical identity and/or percentage of composition has been withheld as a trade secret. 4.
PAGE 3
7. Handling and storage Precautions for safe handling Conditions for safe storage, including any incompatibilities Pressurized container: Do not pierce or burn, even after use. Do not use if spray button is missing or defective. Do not spray on a naked flame or any other incandescent material. Do not smoke while using or until sprayed surface is thoroughly dry. Do not cut, weld, solder, drill, grind, or expose containers to heat, flame, sparks, or other sources of ignition.
PAGE 4
9. Physical and chemical properties Appearance Physical state Liquid. Form Aerosol. Color Clear. Odor Mild hydrocarbon. Odor threshold Not available. pH Not available. Melting point/freezing point -72.4 °F (-58 °C) estimated Initial boiling point and boiling range 430 °F (221.1 °C) estimated Flash point 204 °F (95.6 °C) Tag Closed Cup Evaporation rate Slow. Flammability (solid, gas) Not available. Upper/lower flammability or explosive limits 0.
PAGE 5
Product Species Test Results Cable Clean® HF™ High Voltage Cleaner (High Flash) Acute Dermal LD50 Rabbit 2058.4412 mg/kg estimated Inhalation LC50 Rat 5.3519 mg/l, 4 Hours estimated Oral LD50 Rat 5146.103 mg/kg estimated * Estimates for product may be based on additional component data not shown. Causes skin irritation. Skin corrosion/irritation Serious eye damage/eye irritation Direct contact with eyes may cause temporary irritation. Respiratory sensitization Not available.
PAGE 6
Contaminated packaging Empty containers should be taken to an approved waste handling site for recycling or disposal. Since emptied containers may retain product residue, follow label warnings even after container is emptied. 14.
PAGE 7
Spills or releases resulting in the loss of any ingredient at or above its RQ require immediate notification to the National Response Center (800-424-8802) and to your Local Emergency Planning Committee. Clean Air Act (CAA) Section 112 Hazardous Air Pollutants (HAPs) List Not regulated. Clean Air Act (CAA) Section 112(r) Accidental Release Prevention (40 CFR 68.130) Not regulated. Not regulated. Safe Drinking Water Act (SDWA) Food and Drug Administration (FDA) Not regulated.
PAGE 8
Country(s) or region United States & Puerto Rico Inventory name Toxic Substances Control Act (TSCA) Inventory On inventory (yes/no)* Yes *A "Yes" indicates that all components of this product comply with the inventory requirements administered by the governing country(s) A "No" indicates that one or more components of the product are not listed or exempt from listing on the inventory administered by the governing country(s). 16.