Cut Sheet

6. Accidental release measures
Keep unnecessary personnel away. Keep people away from and upwind of spill/leak. Eliminate all
ignition sources (no smoking, flares, sparks, or flames in immediate area). Wear appropriate
protective equipment and clothing during clean-up. Avoid breathing mist or vapor. Do not touch
damaged containers or spilled material unless wearing appropriate protective clothing. Ensure
adequate ventilation. Local authorities should be advised if significant spillages cannot be
contained. For personal protection, see section 8 of the SDS.
Personal precautions,
protective equipment and
emergency procedures
Eliminate all ignition sources (no smoking, flares, sparks, or flames in immediate area). Keep
combustibles (wood, paper, oil, etc.) away from spilled material. This product is miscible in water.
Prevent product from entering drains.
Small Spills: Absorb with earth, sand or other non-combustible material and transfer to containers
for later disposal. Wipe up with absorbent material (e.g. cloth, fleece). Clean surface thoroughly to
remove residual contamination.
Never return spills to original containers for re-use. For waste disposal, see section 13 of the SDS.
Methods and materials for
containment and cleaning up
Avoid release to the environment. Inform appropriate managerial or supervisory personnel of all
environmental releases. Prevent further leakage or spillage if safe to do so. Avoid discharge into
drains, water courses or onto the ground.
Environmental precautions
7. Handling and storage
Keep away from open flames, hot surfaces and sources of ignition. When using do not smoke.
Avoid breathing mist or vapor. Avoid contact with eyes, skin, and clothing. Avoid prolonged
exposure. Provide adequate ventilation. Wear appropriate personal protective equipment. Wash
hands thoroughly after handling. Avoid release to the environment. Observe good industrial
hygiene practices. Use care in handling/storage. For product usage instructions, see the product
label.
Precautions for safe handling
Keep away from heat, sparks and open flame. Store in a cool, dry place out of direct sunlight.
Keep container tightly closed. Store in a well-ventilated place. Keep in an area equipped with
sprinklers. Store away from incompatible materials (see Section 10 of the SDS).
Conditions for safe storage,
including any incompatibilities
8. Exposure controls/personal protection
Occupational exposure limits
US. OSHA Table Z-1 Limits for Air Contaminants (29 CFR 1910.1000)
ValueComponents
Form
Type
PEL 290 mg/m32,6-dimethyl-4-heptanone
(CAS 108-83-8)
50 ppm
PEL 400 mg/m3distillates (petroleum),
hydrotreated light (CAS
64742-47-8)
100 ppm
PEL 5 mg/m3 Mist.distillates (petroleum),
hydrotreated middle (CAS
64742-46-7)
400 mg/m3
100 ppm
PEL 400 mg/m3naphtha (petroleum),
hydrotreated heavy (CAS
64742-48-9)
100 ppm
PEL 560 mg/m3turpentine, oil (CAS
8006-64-2)
100 ppm
US. ACGIH Threshold Limit Values
ValueComponents
Form
Type
TWA 25 ppm2,6-dimethyl-4-heptanone
(CAS 108-83-8)
TWA 5 mg/m3 Inhalable fraction.distillates (petroleum),
hydrotreated middle (CAS
64742-46-7)
TWA 20 ppmturpentine, oil (CAS
8006-64-2)
3 / 10
Material name: Knock'er Loose® Penetrating Solvent
No. 03024 (Item# 1003276) Version #: 04 Revision date: 08-18-2017 Issue date: 11-19-2013
SDS US