MSDS

SAFETY DATA SHEET
1. Identification
Product identifier Heavy Duty Clear Penetrating Grease
Other means of identification
Product code
03056
Recommended use
Penetrating grease
Recommended restrictions
None known.
Manufacturer/Importer/Supplier/Distributor information
Manufactured or sold by:
Company name
CRC Industries, Inc.
Address
885 Louis Dr.
Warminster, PA 18974 US
Telephone
General Information
215-674-4300
Technical
Assistance
800-521-3168
Customer Service
800-272-4620
24-Hour Emergency
800-424-9300 (US)
(CHEMTREC)
703-527-3887 (International)
Website
www.crcindustries.com
2. Hazard(s) identification
Category 1Flammable aerosols
Physical hazards
Liquefied gasGases under pressure
Category 2BSerious eye damage/eye irritation
Health hazards
Category 3 narcotic effectsSpecific target organ toxicity, single exposure
Not classified.
Environmental hazards
Not classified.
OSHA defined hazards
Label elements
Signal word
Danger
Hazard statement
Extremely flammable aerosol. Contains gas under pressure; may explode if heated. Causes eye
irritation. May cause drowsiness or dizziness.
Precautionary statement
Prevention
Keep away from heat/sparks/open flames/hot surfaces. - No smoking. Do not spray on an open
flame or other ignition source. Do not apply while equipment is energized. Pressurized container:
Do not pierce or burn, even after use. Extinguish all flames, pilot lights and heaters. Vapors will
accumulate readily and may ignite. Use only with adequate ventilation; maintain ventilation during
use and until all vapors are gone. Open doors and windows or use other means to ensure a fresh
air supply during use and while product is drying. If you experience any symptoms listed on this
label, increase ventilation or leave the area. Avoid breathing gas, mist or vapor. Wash hands
thoroughly after handling.
Response
If inhaled: Remove person to fresh air and keep comfortable for breathing. Call a poison
center/doctor if you feel unwell. If in eyes: Rinse cautiously with water for several minutes.
Remove contact lenses, if present and easy to do. Continue rinsing. If eye irritation persists: Get
medical attention.
Storage
Store in a well-ventilated place. Store locked up. Protect from sunlight. Do not expose to
temperatures exceeding 50°C/122°F. Exposure to high temperature may cause can to burst.
Disposal
Dispose of contents/container in accordance with local/regional/national regulations.
Hazard(s) not otherwise
classified (HNOC)
Static accumulating flammable liquid can become electrostatically charged even in bonded and
grounded equipment. Sparks may ignite liquid and vapor. May cause flash fire or explosion.
Supplemental information
Not applicable.
1 / 8
Material name: Heavy Duty Clear Penetrating Grease
897 Version #: 01 Issue date: 01-14-2014
SDS US